Sun Microsystems Sun StorEdge D240 Installation Manual
Read Online
Read the Sun Microsystems Sun StorEdge D240 Installation Manual online using the built-in PDF viewer.
Key Pages of Document
4150 Network Circle Santa Clara, CA 95054 U.S.A. 650-960-1300 Send comments about this document to: [email protected] Sun StorEdge™ D240 Media Tray Installation Guide For the Sun™ Rack Part No. 816-7769-10 November 2002, Revision A ...
Sun Microsystems, Inc. has intellectual property rights relating to technology embodied in the product that is described in this document. In particular, and without limitation, these intellectual property rights may include one or more of the U.S. patents listed at http://www.sun.com/patents and one or more additional paten ...
Installation This guide consists of the following sections: I “Tools and Parts Needed” on page 1 I “Installing the Media Tray” on page 3 Tools and Parts Needed You will need the following tools and parts: I One No. 2 Phillips screwdriver I Two mounting rails I One Sun StorEdge™ D240 media tray I Mounting hardware I Two mounting ears Preparing the Sun Rack for Service For information about removing the side panels, e ...
Installing the Media Tray 1. Estimate or measure the available mounting space in the rack. Allow for a media tray height of 88.9-mm (3.5-in.). 2. Align the holes on a mounting ear with a corresponding pair of 12.7-mm (0.5-in.) rack holes. 3. Attach the mounting ears to the media tray front sides. FIGURE 1 Attaching the Mounting Ear to the Media Tray A B ...
3 4. Loosely attach the rear mounting rail to the front mounting rail using four M5 screws.. FIGURE 2 Attaching the Rear Mounting Rail to the Front Mounting Rail 5. Attach the mounting rail assemblies to the rack using M6 screws. Align the bottom of the rail with the RU markings on the rack mounting rails. 6. Tighten the screws holding the front bracket to the rear bracket. 7. Partially install the rear media tray ...
8. Slide the media tray into the two rails until the mounting ears are fully seated against the front of the rack. FIGURE 3 Sliding the Media Tray Into the Mounting Rails 9. Use four screws (two per side) to secure the media tray mounting ears to the rack and the rear of the media tray to the rear of the rack. Tighten the two rear screws. ...
