Stanley HD45 Operation & User’s Manual

New Britain, CT 06053 U.S.A. 66301 9/2018 Ver. 15 HD45 HYDRAULIC HAMMER DRILL USER MANUAL Safety, Operation and Maintenance ...

DECLARATION OF CONFORMITY ÜBEREINSTIMMUNGS-ERKLARUNG DECLARATION DE CONFORMITE CEE DECLARACION DE CONFORMIDAD DICHIARAZIONE DI CONFORMITA ______________________________________________________________________ I, the undersigned: Ich, der Unterzeichnende: Je soussigné: El abajo firmante: lo sottoscritto: Nuerenberg, David Surname ...

TABLE OF CONTENTS SAFETY SYMBOLS ..............................................................................................................................................4 SAFETY PRECAUTIONS ....................................................................................................................................5 TOOL ST ...

Always observe safety symbols. They are included for your safety and for the protection of the tool. LOCAL SAFETY REGULATIONS Enter any local safety regulations here. Keep these instructions in an area accessible to the operator and maintenance personnel. Safety symbols and signal words, as shown below, are used to emphasize all opera ...

Tool operators and maintenance personnel must always comply with the safety precautions given in this manual and on the stickers and tags attached to the tool and hose. These safety precautions are given for your safety. Review them carefully before operating the tool and before performing general maintenance or repairs. Supervising pe ...

• To avoid personal injury or equipment damage, all tool repair, maintenance and service must only be performed by authorized and properly trained personnel. • Never rest the tool on your foot. • Never allow your face to come close to the tool. • Never start the tool while it is lying on the ground. • WARNING: Some dust creat ...

The safety tag (p/n 15875) at right is attached to the tool when shipped from the factory. Read and understand the safety instructions listed on this tag before removal. We suggest you retain this tag and attach it to the tool when not in use. NOTE: THE INFORMATION LISTED ON THE STICKERS SHOWN, MUST BE LEGIBLE AT ALL TIMES. REPLACE DEC ...

The rated working pressure of the hydraulic hose must be equal to or higher than the relief valve setting on the hydraulic system. There are three types of hydraulic hose that meet this requirement and are authorized for use with STANLEY hydraulic tools. They are: Certifi ed non-conductive — constructed of thermoplastic or synthetic ...

Oil Flow Hose Lengths Inside Diameter USE (Press/Return) Min. Working Pressure GPM LPM FEET METERS INCH MM PSI BAR Certifi ed Non-Conductive Hose - Fiber Braid - for Utility Bucket Trucks 4-9 15-34 up to 10 up to 3 3/8 10 Both 2250 155 Conductive Hose - Wire Braid or Fiber Braid -DO NOT USE NEAR ELECTRICAL CONDUCTORS 4-6 15-23 up to 25 ...

HTMA / EHTMA REQUIREMENTS TOOL TYPE HTMA HYDRAULIC SYSTEM REQUIREMENTS TYPE I TYPE II TYPE RR TYPE III Flow range 4-6 GPM (15-23 LPM) 7-9 GPM (26-34 LPM) 9-10.5 GPM (34-40 LPM) 11-13 GPM (42-49 LPM) Nominal operating pressure (At the power supply outlet) 1500 psi (103 bar) 1500 psi (103 bar) 1500 psi (103 bar) 1500 psi (103 bar) Syste ...