SSV Embedded Systems IGW/936-L First Steps

Text of the manual

LTE Router IGW/936-L

with eSOM/3517 First Steps SSV Embedded Systems Dünenweg 5 D-30419 Hannover Phone: +49 (0)511/40 000-0 Fax: +49 (0)511/40 000-40 Email: [email protected] Document Revision: 1.4 Date: 2018-08-29

LTE Router IGW/936-L – First Steps

2 Document Revision 1.4 CONTENT 1 INTRODUCTION ............................................................................................................... 3 1.1 Checklist ................................................................................................................................. 3 1.2 Conventions

LTE Router IGW/936-L – First Steps

Document Revision 1.4 3 1 INTRODUCTION This documentation gives you an overview about the initial operation and the first steps of use with the LTE Router IGW/936-L. 1.1 Checklist Compare the content of your IGW/936-L start-up package with the checklist below. If any item is missing or appears to be damaged, please contac

LTE Router IGW/936-L – First Steps

4 Document Revision 1.4 2 SAFETY GUIDELINES Please read the following safety guidelines carefully! In case of property or personal damage by not paying attention to this manual and/or by incorrect handling, we do not assume liability. In such cases any warranty claim expires. • The power supply should be in immediate pr

LTE Router IGW/936-L – First Steps

Document Revision 1.4 5 3 REQUIRED EQUIPMENT To operate the IGW/936-L the following hardware is required: • a valid SIM card with an appropriate mobile tariff. Please refer to chapter 4 to see how the SIM card is inserted. • one Ethernet cross-over cable or two Ethernet patch cables and a switch. To configure the IGW/

LTE Router IGW/936-L – First Steps

6 Document Revision 1.4 4 SIM CARD The internal SIM card of the IGW/936-L can be changed through the slot on the backside. To insert the SIM card just push it by hand as deep as possible into the slot. Please note: Pay attention to the correct orientation of the SIM card like shown in fig. 1! Then use a screw driver to pu

LTE Router IGW/936-L – First Steps

Document Revision 1.4 7 5 CONNECTIONS For a quick and easy start with the IGW/936-L there are a few cable connections necessary. The following chapters describe how these connections have to be made. 5.1 LTE Antenna Connect the LTE antenna with the IGW/936-L like shown in fig. 3 and place it where the LTE signal strength

LTE Router IGW/936-L – First Steps

8 Document Revision 1.4 5.2 Ethernet Link The Ethernet link between the PC and LAN1 of the IGW/936-L can be made on two ways: • Direct with an Ethernet cross-over cable like shown in fig. 4. • With two standard Ethernet patch cables over a hub or switch like shown in fig. 5. Figure 4: Ethernet link with cross-over cab

Other Network Router Manuals