Seiko 7C17B Technical Manual

Text of Seiko 7C17B Technical Manual

PARTS CATALOGUE/TECHNICAL GUIDE

Cal. 7C17B (× 1.0) Movement Cal.No. Movement size (mm) Outside diameter Casing diameter 5.2 mm 2 hands φ 28.6 mm×27.0 mm between 3 o'clock and 9 o'clock sides φ 27.0 mm×25.4 mm between 3 o'clock and 9 o'clock sides Time indication Step motor (Load compensated driving pulse type) Driving system Electronic circuit reset switch Additional mechanism Monthly rate at normal temperature range : less than 15 seconds Loss/gain

Disassembling procedures Figs.

Moebius A SEIKO Watch Oil S-6 Normal Quantity 0022 493 Coil block screw Antimagnetic shield plate screw 0022 648 Battery clamp screw 1 Case back 7 Movement 8 Bezel gasket 9 Case (with bezel) 6 Winding stem (with crown) 2 Case back gasket 4 Casing clamp screw (2 pcs.) 0022 421 18 Minute wheel 0261 935 17 Setting wheel 2081 925 15 Dial sheet 0105 925 16 Hour wheel 0271 927 14 Dial sheet screw (3 pcs.) 0022 257 13 Dial washer 04

Eccentric dial pin

Tube for circuit block spacer A Tube for circuit block spacer B Tube for casing clamp screw Setting lever pin Tube for antimagnetic shield plate screw Tube for traon wheel bridge Casing clamp screw Tube for coil block screw 3/6 29 Train wheel bridge screw (2 pcs.) 30 Train wheel bridge 0125 925 31 Fourth wheel and pinion 0241 927 32 Third wheel and pinion 0231 935 33 Fifth wheel and pinion 0701 925 34 Step rotor 41

Use the universal movement holder for disassembling and reassembling.

5 Casing clamp ● Setting position Cross section Bezel gasket Casing clamp Case middle 7 ● When you remove the movement, push the movement out of the back lid side to the bezel. When you build it in, push it from the bezel side. 9 Bezel Glass 3 How to install the contact point spring ● Push the center of the contact spring, see the drawing, until it touches winding stem. Be careful
Eccentric dial pin Eccentric dial pin 12 Holding ring for dial Holding ring for dial Protrusion 11 Dial Be sure to set the protrusion of the holding ring for dial in place. Movement The foot of the dial has been tightened with the eccentric dial pin. Turn the screw driver right and tighten to attach, and turn left and loosen to remove it. Hole for dial leg Hole for dial leg 31 Fourth wheel and pinion 5/6 38 Yoke Setting lever spring Train wheel

Center wheel bridge

39 Winding stem To prevent any crack onto the main plate, gently set the winding stem while turning it. Lubricating II. VALUE CHECKING ● Coil block resistance 2.0 ~ 2.5 kΩ ● Current consumption For the whole of the movement:less than 1.30μ A For the circuit block alone: less than 0.20μ A Remarks: When the current consumption exceeds the standard value for the whole of the movement but is less than the

Seiko Watch Owners Instructions: