White 951 Reference Manual

NEEDLE.ThREADFABRICSTITCHING GUIDE SETTING THE NEEDLE WINDING THE BOBBIN TO REMOVE OR REPLACE BOBBIN CASE TO THREAD THE BOBBIN CASE UPPER THREADING SETTING THE STITCH LENGTH STITCH LENGTH CHART (APPROXIMATE) SEWING IN REVERSE PREPARING TO SEW REMOVING THE WORK ADJUSTING THE TENSIONS STRAIGHT STITCHING ADJUSTING PRESS ...

Stitch Length Dial Reverse Push Button Zigzag Width Lever Stop Lock Fabric Selector Bed Needle Plate Slide Plate Presser Foot Presser Foot Thumb Screw Needle Bar Thread Guide REFERENCE GUIDE FEATURES AND PARTS Fig. 1 —2-- ...

—3— z N Needle Clamp Screw Arm Thread Guide Thread Tension Dial Face Plate Push Button Light Switch Take-Up Lever Darner Upper Arm Thread Guide Arm-Top Cover Pattern Indicating Board Pattern Selector Dial Presser Bar Lifter Tl ...

8 30 Heavy upholstery 8 30 fabric, ticking, 3 to to Heavy Duty denim, leatherette 10 40 Medium heavy drapery 10 40 fabric, velveteen, 2 to to Heavy Duty Su ...

See Fig. 3. Raise the need’e bar “A” to its highest point, turning wheel toward you by hand (Fig. 4). Then loosen the needle clamp screw “8” and the needle can be inserted into clamp “C”. Place needle (flat side to back) in the needle clamp and push it upward as far as it will go into the needle clamp hole, tightening the nee ...

Disengage the hand wheel (Fig. 6) from the stitching mechanism by turning the stop motion knob toward you or counterclockwise. Place a spool of thread on one of the spool pins, lead thread through the upper thread guides on the arm, and down through the tension disc 11 (Fig. 7) at the base of the machine. Run end of thread through a hole i ...

Raise needle to its highest position. The bobbin case cannot be removed unless the needle is above the needle plate. Open slide plate II (Fig. 1) by sliding it toward you. Grasp the bobbin case hinge latch ‘A” (Fig. 9) between thumb and forefinger. To remove, pull toward you. To replace with full bobbin, leave at least th ...

Hold bobbin case between thumb and forefinger of left hand so that the slot in the edge of the bobbin case is on top (Fig. 11). Take the bobbin between thumb and forefinger of the right hand so that the thread on the bobbin leads from left to right and extends about four inches from the bobbin (Fig. 11). llllB llllllll Fig. 10 For b ...

(Fig. 14) and needle to their highest positions. (2) Place spool of thread on spool pin. (3) Lead thread through rear and front arm thread guides “A” (4) Down and between tension discs “B” from right to left and up and over hook “D”. (5) Lead thread up and through t ...