Draper VC300 Instructions Manual

Text of Draper VC300 Instructions Manual

I STOCK No.59333 I PART No.VC300

01/2000 • INSTRUCTIONS • IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY TO ENSURE THE SAFE AND EFFECTIVE USE OF THIS TOOL. GENERAL INFORMATION This manual has been compiled by Draper Tools and is an integrated part of the power tool equipment, which should be kept with the machine. This manual describes the purpose for which this tool has been designed and contains all th

I STOCK No.59333 I PART No.VC300

CONTENTS: Page No’s. Specification.....................................................................................................3 Guarantee ........................................................................................................3 Power supply....................................................................................................4 General safety instructions......

- 3 -

The Draper Tools policy of continuous improvement determines the right to change specification without notice. Part No....................................................................................................................VC300 Stock No...................................................................................................................59333 Voltage..............................................................................

Extension cable length

Wire Size mm2 7.5m 0.75 0.75 1.0 1.25 15m 0.75 0.75 1.0 1.5 22.5m 0.75 0.75 1.0 1.5 30m 0.75 0.75 1.25 1.5 45m 0.75 1.25 1.5 2.5 Ampere rating (on Name plate) CONNECTING YOUR MACHINE TO THE POWER SUPPLY: (240V) To eliminate the possibility of an electric shock your machine has been fitted with a BS approved, non rewireable moulded plug and cable which incorporates a fuse, the value of which is indicated on the

- 5 -

GENERAL SAFETY INSTRUCTIONS FOR POWER TOOLS 1. KNOW YOUR POWER TOOL Read and understand the owner's manual and labels affixed to the tool. Learn its application and limitations as well as the specific potential hazards peculiar to this tool. 2. KEEP WORK AREA CLEAN Cluttered areas and benches invite accidents. Floors must not be slippery due to oil or sawdust. 3. AVOID DANGEROUS ENVIRONMENTS Do not use power tools in damp or wet locations, or expose

Release button for

dust container 5. Dust container with filter 6. Drive belt cover 7. Brush housing GETTING TO KNOW YOUR ✚✌ ✘✌ ✙✌ ✕✌ ✛✌ ✖✌ ✗✌

- 7 -

OPERATING INSTRUCTIONS THE VC300 IS ASSEMBLED AND READY FOR USE TO OPERATE Connect the vacuum to the power supply. Hold the handle ✪✌firmly, with your thumb slide the switch ✫✌forward to turn the vacuum on, and back to turn off. REMOVAL AND CLEANING OF FILTER To remove the filter for cleaning depress the release button ✬✌and remove the dust container ✭✌carefully. Remove the dust filter ✮✌so you do not disturb any dust colle

REPLACING THE DRIVE BELT

IMPORTANT Disconnect the vacuum from the power supply before replacing any parts. 1. Remove screw ✯✌to release front cover ✰✌. FIG.3. 2 Remove the two screws ✱✌holding the brush housing ✳✌in place and remove. FIG.4. 3.Holding the brush ✴✌in the centre, pull the belt off the driveshaft and remove the brush with the bearings ✵✌assembled. FIG.5.. 4. Clean the brush if required. Slide a n

Draper Vacuum Cleaner Owners Instructions: