Draytek VIGOR2820 series Quick Start Manual

protected by copyright. No part may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language without written permission from the copyright holders. Trademarks The following trademarks a ...

Manufacturer: DrayTek Corp. Address: No. 26, Fu Shing Road, HuKou County, HsinChu Industrial Park, Hsin-Chu, Taiwan 303 Product: Vigor2820 Series Router DrayTek Corp. declares that Vigor2820 Series of routers are in compliance with the following essential requirements and other relevant provisions of R&TTE Directive 1999/5 ...

1. Introduction........................................................................................................... 1 1.1 Panel Explanation ...................................................................................................................... 2 1.1.1 For Vigor2820 ................................. ...

to DSL/Cable modem or fiber media converter for policy-based load-balance, fail-over and BoD (Bandwidth on Demand); it also features advanced bandwidth control mechanism such as IP-layer QoS, NAT Session Limitation, Bandwidth Borrowed, etc., to ...

11..11..11 FFoorr VViiggoorr22882200 LED Status Explanation Blinking The router is powered on and running normally. ACT (Activity) Off The router is powered off. On A USB device is connected and active. USB Blinking The data is transmitting. CSM On The profile of CSM (Content Security Management) for IM/P2P appl ...

the hole and keep for more than 5 seconds. When you see the ACT LED begins to blink rapidly than usual, release the button. Then the router will restart with the factory default configuration. LAN (1-4) Connecters for local networked dev ...

LED Status Explanation Blinking The router is powered on and running normally. ACT (Activity) Off The router is powered off. On A USB device is connected and active. USB Blinking The data is transmitting. CSM On The profile of CSM (Content Security Management) for IM/P2P application is enabled from Firewall >> Gener ...

making network connection through WPS. Press "Wireless LAN ON/OFF/WPS" button once to enable (WLAN LED on) or disable (WLAN LED off) wireless connection. Factory Reset Restore the default settings. Usage: Turn on the router (ACT LED ...

LED Status Explanation Blinking The router is powered on and running normally. ACT (Activity) Off The router is powered off. On A USB device is connected and active. USB Blinking The data is transmitting. CSM On The profile of CSM (Content Security Management) for IM/P2P application is enabled from Firewall >> Gen ...