EtroVISION EV8180F Installation Manual
Text of the manual
About This Guide
The Installation Manual provides instructions for the initial setup & configuration of:
• EV8180U
• EV8180F
Before Using the IP Camera/Video Server
Check the PC requirements
Review the OS platform requirements
Read an special and import precautionary information
Having basic knowledge of network setup and configuration will be he
Dual Streaming Capabilities ........................................................................ 1
1.2
Package Checklist....................................................................................... 1
1.3
Frontal Camera View........................
This guide is for the use with firmware version 0.1.2.
Please pay close attention to areas that are highlighted in YELLOW. These areas
highlight special instructions for this firmware release or functionality that is not yet
available.
1.1 Dual Streaming Capabilities
Cameras support dual streams simultaneously in pre-stage firmware Include:
1.4 Rear Camera View
1.5 I/O Cable
The blue, red and green plugs are HDTV video out connectors.
The two block terminals are digital I/O and RS-485/422 connectors.
The GND port is also used for restoring factory default settings using the blue
metal pin which serves is used specifically for restoring factory default settings.
2 INITIAL CONFIGURATION
2.1 Initial Requirements
Software Requirements
Installation and configuration require the following:
• Microsoft Windows 2000 or XP Operating System
• Microsoft Internet Explorer version 6 or higher
NOTE: Other browsers (i.e. Mozilla Firefox) are not currently supported.
Install EtroScan™
EtroScan™ is a utility is used to co
Power on IP Camera
The positive and negative lines need to be connected. The middle port (outline in
red) is the positive.
The left and right are negative, and depend on if using DC12V or AC24V adapter.
Connect the power adapter to the power connector. The adapter should be
connected to 110v~22OV AC socket. There is no power button on the camera, so
connec