Eumig MARK 610D Operation & User’s Manual

information purposes only. Due to the age of the information and the difficulty in converting it to computer formats it may not be up to date or correct, we make no representations or warranties of any kind, express or implied, about the completeness, accuracy, reliability, suitabilit ...

.' 1---,,1'-- Film-format selector Zoom ring Focusing knob Pilot light (Mark 610 OJ How to operate your projector in a nutshell o Plug in the projector. But first check e Move the function sWitch to the the line (mains) voltage and auto threading position. frequency. e Feed the film end into the threading f) Sw ...

The equipment should be disconnected from the mains when not in use. Live parts inside - disconnect from mains before removing the cover. Important: When operating the projector, do not obstruct the air stream emerging from the ventilation slots. VALID FOR UK ONLV! IMPORTANT: The wires in the mains lead are coloured in accorda ...

jector which you just bought is the product of the accumulated engineering and manufacturing know-how of a company that has been making movie projectors for over forty years: Eumig. You will find that your modern projector combines outstanding performance with operating simplicity and dependability. Your ...

e Slow-motion knob 8 Carrying handle o Framing lever e Reel arm e Lens o Mounting holes for daylight viewer (an accessory) e Focusing knob f) Reel-spindle adapter (!) Tilt control mFilm cutter 4» Function switch mFilm-format selector ~ Pilot light (Mark 610 D) mPower cord (mains lead) C Sync cable outlet G Voltage sele ...

. . . make sure that your house current (AC), line (mai,ns) frequency (50 or 60 Hz, or cycles) and voltage are the same as those shown on the manufacturer's rating plate on the projector, To change the projector operating voltage: (Caution: First disconnect the power cord [mains lead].) o Remove the back cover after loosening the tw ...

the projector in. o Plug the power cord (mains lead) into an outlet. 6 Swing the reel arm up to the click stop. e Place the full reel on the reel arm (With the perforations facing you) and flip over the reel guard. Films wound the wrong way (not as shown here) must be rewound tw ...

to warm it up be for e loading it. Should the motor stop for some reason, such as a momentary power failure, move the function switch to the "STOP" (off) position, then back to the desired operating mode. Slow-motion and still projection t,., lSD/SEC. If you wish to show ...

(Mark 610 D) The tripping contact incorporated in the Eumig Mark 610 D makes it po,ssible to start and stop a cassette recorder simultaneously with the projector. However, it can be used only with re,corders havi,ng a remote-control jack. The recorder will start when the projector's function switch i ...

All moving parts of the Mark 610 D are permanently lubricated and requi·re no attention. The film gUides and film channel should be cleaned from time to time. With a soft cloth or a camel's hair brush, carefully remove dust and emulsion particles. To gain access to the film channel, pressure pad and film guides, take off the lamp h ...