Evo Aeroneb Go Instruction Manual

Battery Powered Controller to be free from defective workmanship and materials for a period of two years from the date of purchase.The Nebulizer unit shall be warranted for a period of one year from the date of purchase. Check with your dealer for more details.This warranty is limited to the original purchaser of the Aeroneb® Go Nebulizer. Any defective part or assembly will be repaired or re ...

Thank you for purchasing the Aeroneb® Go Nebulizer. Certain conditions such as asthma, COPD (chronic obstructive pulmonary disease) and cystic fibrosis require that prescribed liquid medication be turned into a fine mist, called an aerosol, and then inhaled into the lungs.The Aeroneb® Go turns liquid medication into an aerosol, which you can then inhale through a mouthpiece or an ...

always follow basic safety precautions. READ ALL INSTRUCTIONS BEFORE YOU USE YOUR NEBULIZER WARNING: • The AC/DC Adapter does not charge batteries. • If you are using batteries and the green light is flashing, your batteries are low.You may finish your treatment and then change the three "AA" batteries immediately. • Do not share your Aeroneb® Go Nebulizer with others ...

• Do not place or drop this product into water or any liquid when it is plugged into a power source. • Keep this product and cords away from heated surfaces. WARNING: • Be sure the device has been properly cleaned before each use to avoid possible contamination. • Clean the device after every use. Medication remaining in the device will dry and reduce the efficiency of the device resulting in longer times to dispen ...

become unusable due to an electrical outage, battery depletion, or mechanical failure.We recommend that you have spare batteries and have a backup device available to you. CLASSIFICATIONS AND MARKINGS The symbols that appear on the Aeroneb® Go Nebulizer and its accessories are described in the table below: TROUBLESHOOTING GUIDE If you have difficulty operating your Aeroneb® Go ...

NOTE: Clean all parts of your Aeroneb® Go Nebulizer (as described in this instruction manual) before first use, after each use, or after extended storage. PRIOR TO ASSEMBLY: Check all parts for visible damage. Replace any damaged parts before you use the Aeroneb® Go. In the case of missing parts, malfunction or damage, contact your local Aeroneb® Go representative or evo Medical Solutions. IMPORTANT NOTICE Before ...

(containing the OnQ™Aerosol Generator) to the Nebulizer Body. NOTE: Make sure the Aeroneb® Go is unplugged before you add medication to the Medication Cup. 2. Fill the Medication Cup with the prescribed nebulizer medication. Never pour more than 6 mL into the cup.The continuous line on the inside surface of the cup indicates the maximum filling level. (When the medication cup contains medication, the cup should rem ...

1. Turn the Battery Powered Controller upside down. Slide the battery cover in the direction of the arrow to remove the lid. Put in three (3) "AA" disposable alkaline or lithium batteries, matching them to the plus (+) and minus (-) markings inside the Battery Powered Controller. Replace the cover on the Battery Powered Controller and slide the cover until it locks in place. You can expect at least three (3) hou ...

comes on while depressing the button, immediately replace the three “AA”batteries. 5. Place the mouthpiece between your teeth, with your lips firmly sealed around the mouthpiece. If you use an aerosol mask, place the mask over your mouth and nose. Breathe in and out slowly through your mouth until aerosol formation stops. Do not cover ventilation holes. NOTE: Aerosol mask is not prov ...

AN AC/DC ADAPTER 1. Alternatively, you can power the device by using the AC Adapter if provided. Plug the AC adapter into a standard AC electrical outlet, a green light on the adapter indicates that the AC adapter is turned on. Plug the AC cable into the Control Module, indicated by the Input Symbol (See Classifications and Markings, pg. 4). NOTE: The AC/DC Adapter does not charge batteries. 2. Turn on the unit by ...