FireBird 16 Instruction Manual

heat to your house as well ...

Page 1.0 INTRODUCTION 2.0 IMPORTANT SAFETY NOTES 3.0 TERMS & CONDITIONS OF GUARANTEE 4.0 INSTALLATION INSTRUCTION 4.1 Performance 4.2 Health and Safety 4.3 Air Supply 4.4 Fireplace 4.5 Hearth 4.6 Chimney/Flue 4.7 Installing and Back Filling 4.8 Heating and Hot Water System 4.9 System Controls 4.10 Checks before Lighting 4.11 Commiss ...

backboiler inset stove (hereinafter referred to as “the inset stove”). The design for this product stems from our original concept, “the Firebird backboiler”. The stove is manufactured in its entirety in our factory in Baile Mhic Íre, Macroom, Co. Cork ...

- BS EN 12828:2003 Heating systems in buildings - Design of water based heating systems - BS EN 12831:2003 Heating systems in Buildings - Method of calculation of the design heat load. Please read this manual carefully prior to installation of the inset stove. Installation of the inset stove ...

4.1 PERFORMANCE The following highlights the output and test performance of the inset stove: Firebird 16” Multifuel Backboiler Inset Stove Fuel Type Wood Ancit Ancit Output to Water - kW 7.3 8.3 7.2 Output to Space - kW 2.5 3.6 0.2 Efficiency - % 75.0 79.9 81.5 CO (@13% O2) 0.61 0.36 0.44 BS Standard BS EN 13229:2001 Test Typ ...

appliance are cured and do not present any known hazards when used for their intended purpose. NOTE: If your Firebird Inset Stove is not installed, operated & maintained properly a house fire may result! Additional Material Safety Items Handling - Adequate facilities must be availa ...

fitted in the same room as the appliance. 4.4 FIREPLACE When fitting into an existing fireplace, remove fireback or boiler and clear out any loose back fill material. Access from the side of the chimney breast should be made available to facilitate pipe work connections. In addition, access to the front of the chimney breas ...

pipe. This avoids possible fire risk. Firebird recommend that a thorough inspection of the chimney is carried out prior to installation and on a regular basis thereafter. The chimney should be of sound construction, free from debris, capable of withstanding extremely high temperatures and have no evidence of cracks or ...

inset stove if required. 4. Remove any excess fire cement from around the flange. 5. Make the connections to the boiler and ensure the primary flow pipe rises from the boiler to so that no air is trapped in the boiler. 6. Ensure the boiler is fixed to the hearth. There are 4 preformed holes on the side frames of the base to fa ...