Digital Electronics PS3650A-T42 Installation Manual

Text of Digital Electronics PS3650A-T42 Installation Manual

(1) PS-A Unit (1)

(2) English and Japanese Installation Guides (one of each) (3) Warning/Caution Information (1) (4) Installation Gasket (1) (attached to the PS-A unit) (5) Installation Fasteners (Set of 4) (6) USB Cable Clamp (2 ports) (2) (7) Power Plug (1) • Be careful when installing

Part Names and Functions

Name Description A Display Display Area B Touch Panel User input is available by means of touching the panel. C Power LED / Status Lamp (POWER) The lamp shows the status of the PS-A’s power and operation. The display colors and their details are as follows. D DISK Access Lamp (DISK) The lamp shows the status PS-A’s DISK access

H Power Switch

Supported by AC type only. I Power Connector For connection, install a power plug, which is one of accessories, to the power cable. J Mask Cover - K Expansion Board Base PS-3650A Series only. L Expansion Board Cover The PCI board installation interface is located in the cover opening. PS-3650A Series only M Expansion Board S

• When attaching peripheral units to the PS-A, be sure the PS-A's power cord is

disconnected from the main power supply. General Specifications „ Electrical Specifications Name Description S Ethernet Interface (LAN2) 10BASE-T/100BASE-TX/1000BASE-T Auto Changeover. This interface uses an RJ-45 type modular jack connector. T Ethernet Interface (LAN1) 10BA

„ Environmental Specifications

• When using any of the PS-A’s optional devices, be sure to check that device’s specifications for any special conditions or cautions that may apply to its use. • Be aware that not only does the Hard Disk have a fixed lifetime, but that accidents can always occur. Therefore, be sure to back up your Hard Disk’s data

Digital Electronics Monitor Owners Instructions: