DigiTech HT-2 Owner's Manual

Manufacturer’s Name: Harman Signal Processing Manufacturer’s Address: 8760 S. Sandy Parkway Sandy, Utah 84070, USA declares that the product: Product name: HT-2 Product option: All (requires Class II power adapter that conforms to the requirements of EN60065, EN60742, or equivalent.) conforms to the following Product Specifica ...

Important Safety Instructions 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Do not use this apparatus near water. 5. Clean only with dry cloth. 6. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 7. Do not install n ...

1. Please register online at www.digitech.com within ten days of purchase to validate this warranty. This warranty is valid only in the United States. 2. DigiTech warrants this product, when purchased new from an authorized U.S. DigiTech deal ...

a collection of significant improvements in guitar effects pedals. The HardWire series pedals provide a suite of well-known effects, each with superior tone and control. But these pedals go above and beyond their peers to provide such distinguishing features as true ...

1. Mode Button - Selects the display mode (Normal or Strobe) for the Tuning LED Array. The modes are labeled below the last two LEDs of the Tuning LED Array. 2. Input - Connect your instrument here. This jack enables battery power to the pedal when connected. To prolong battery life, disconnect the cable from the Input jack when not in u ...

the input of another pedal if you want the output signal from your instrument to be audible when the tuner is enabled. 6. Mute Output - Connect this output to the input of your amp or the input of another pedal if you want the output signal from your instrument to be muted when the tuner is e ...

power is low (approximately 15 minutes before it dies), the Indicator LED begins to dim giving you advanced warning that very shortly you will need to replace the battery. 10. Note Display - Displays the note being tuned. The decimal point in the lower right corner of the display will li ...

The HT-2 Tuner has a single 1/4" Input and two 1/4" Outputs – MUTE and THRU. The HT-2 offers true hardwire bypass when not in use to preserve your guitar’s signal without any loss or buffering into your amp and other effects. If you use the HT-2 on a pedal board with other effects devices, it doesn’t really matter where in your e ...