Digitus DN-7018 Operation & User’s Manual

Chapter 1 Introduction ............................................................................. 1 1.1 Package Contents .......................................................................................... 2 1.2 Features ......................................................................................................... 2 1.3 ...

This product is an access point for IEEE 802.11g/b 2.4GHz wireless network. You can use this access point to build up a wireless LAN. Any wireless LAN station can join the wireless network by using the “Infrastructure Mode”. The product supports WEP, WPA, ESSID and MAC address filter functions to consolidate the wire ...

 One Access Point  One Power Adapter  One User’s Manual 1.2 Features  Complies with the IEEE 802.11b/g (DSSS) 2.4GHz specification.  High data rate 54Mbps network speed.  Seamlessly integrate wireless and wired Ethernet LAN networks.  Auto rate fallback ...

 Certification: FCC, CE 1.4 Physical Description Front Panel On the Access Point’s front panel there are LED lights that inform you of the Access Point’s current status. Below is an explanation of each LED. LED Color Status Description Power Green Lit Power is supplied. Off No Power. Wireless Activit ...

This round connection is standard Reverse SMA connector where any antennas with Reverse SMA connector can connect to the Access Point.  DC Adapter Port Insert the power jack of the power adapter into this port.  LAN Port The Access Point’s LAN port is where you connect to your LAN’s network devices.  Reset Th ...

5 Chapter 2 Wireless LAN Access Point Connection 1. Locate an optimum location for the Wireless LAN Access Point. The best location for your Access Point is usually at the center of your wireless network, with line of sight to all of your mobile stations. 2. Connect the Wireless LAN Access Point to your router, hub or swi ...

6 Chapter 3 Wireless LAN Access Point Configuration 3.1 Getting Started This Access Point provides web-based configuration tool allowing you to configure from wired or wireless stations. Follow the instructions below to get started configuration. From Wired Station 1. Make sure your wired station is in the same subnet ...

7 • IP Address: Select Specify an IP Address. Specify the IP Address and Subnet Mask as following example.  IP Address: 192.168.2.3 (any IP address within 192.168.2.2~192.168.2.254 is available, do not setup 192.168.2.1)  Subnet Mask: 255.255.255.0 8. Reboot the PC. Your PC will now have the IP Address you spec ...

8 5: Click OK to confirm the setting. Your PC will now obtain an IP address automatically from your Broadband Router’s DHCP server. Note: Please make sure that the Broadband router’s DHCP server is the only DHCP server available on your LAN. Once you’ve configured your PC to obtain an IP address automa ...