Dimplex BLF7451 Service Manual

6909610100 7400900000R00 In keeping with our policy of continuous product development, we reserve the right to make changes without notice. © 2016 Dimplex North America Limited Dimplex North America Limited 1367 Industrial Road Cambridge ON Canada N3H 4W3 1-888-346-7539 www.dimplex.com REV PCN DATE 00 - 5-JAN-16 ...

! NOTE: Procedures and techniques that are considered important enough to emphasize. CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment. WARNING: Procedures and techniques which, if not carefully fol ...

again. D & E. Thermostat Controls Adjusts the temperature set point to your individual require- ments. Once the desired set temperature is reached the heater will turn off. The heater will cycle on and off to main- tain the desired set temperature. The default temperature setting is 72°F (22 ...

before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to persons. ! NOTE: The fireplace should not be operated with an accumulation of dust or dirt on or in the unit, as this can cause a build up of heat and eventual damage. For t ...

REPLACEMENT PARTS LIST 12 6 1 2 3 4 14 10 7 8 11 9 5 1. Element. . . . . . . . . . . . . . . . . . . . . . . . 2200510700RP 2. Partially Reflective Glass Replacement Kit.9600750100RP 3. Blower Assembly. . . . . . . . . . . . . . . . . 5300160300RP 4. Front Glass . . . . . . . . . . . . . . . . . . . . . 6908730100RP 5. Flicker Mo ...

THERMISTOR LED STRIPS (RGB) - MEDIA FLAME LED STRIPS (AMBER) CUTOUT THERMAL FLICKER MOTOR BLOWER MOTOR LED STRIPS (RGB) - FLAME M M ELEMENTS LED DRIVER BOARDS ...

! NOTE: All components are replaceable from the front of the fireplace while the unit is mounted on the wall, with the exception of replacement of the power cord. ! NOTE: If the power cord needs replacing or if the unit needs to be removed from the wall for any other reason please begin service by following the “PREPARATION F ...

is a finished surface that is prone to scratches (i.e. hard- wood flooring), it is recommended that a protective barrier be used underneath, (i.e. cloth, cardboard, thick plastic). 5. Proceed to the instructions within this manual relating to the repair being performed - see Table o ...

right side of the unit. 2. Slide the controls assembly out toward the front of the unit. CAUTION: Ensure that the assembly is removed care- fully, ensuring that no wires are caught or over strained. 3. Locate the switchboard (Figure 9). 4. Disconnect the wiring harness from the switchboard. 5. R ...

the wires. 5. Remove the LED driver board off the plastic mounts by pinching the plastic mounting tabs with needle nose pliers. Pull the old board off. 6. Line up the holes on the driver board and gently press the new board onto the mounts. Make sure the board is secure. 7. Reas ...