Elecro Engineering TiTANIUM Installation Instructions & Operating Manual

Elecro declares that the herewith products or ranges ELECTRIC SWIMMING POOL HEATER RANGE Are in conformity with the provisions: of the ELECTROMAGNETIC COMPATIBILITY directive 89/336/EEC, as amended 93/068/EEC. Controlled by AEMC Measures laboratory—technical report no P96045T The harmonised standards have been applied: EN 5501 ...

horizontal and upright i.e. with the control enclosure located above the Titanium flow tube (see diagram below). Under no circumstances should the heater be oper- ated in any other orientation. The heater should be installed at a low point in the filtration system. ...

The temperature gain of the water after it has passed through the heater will be di- rectly proportional to the volume of water being pumped in relationship to the power output of the heater. For example: A 6-kW heater, when connected to a 4000-litre per hour pump, will produce a lift in temperature of ap ...

exiting on the right, this can be reversed by rotating the flow switch 180° (i.e. ½ turn) (see diagram on following page). ELECTRICAL CONNECTION The heater must be installed in accordance with the country / regional requirements & regulations. In any eve ...

hour period. The conclusion of the test should prove that for example a 6-kW heater and a ½ horsepower pump will draw between 6.3-kW to 6.5-kW in one hour. It is impossible for an Elecro heater to waste energy, if it is drawing power then that power will be turned ...

has been installed and has a constant power supply). Rotate the minute hand slowly in a clockwise direction, until the correct hour is located at the tip of the arrow printed on the dial. See Figure 1 below. Please note that the outer dial is printed with the 24 hour clock i ...