Bush A60CT Operating & Installation Instructions Manual

Text of the manual

BUILT-IN VITROCERAMIC HOB

A60CT Important - Please read these instructions fully before using These instructions contain important information which will help you get the best from your appliance and help to ensure safe and correct installation, use and maintanence. If you need help or have damaged or missing parts, call the Customer Helpline: 0345 257 7271

It is important that you should read this manual in

order to get the best performance from your appliance and to also help extend the life of your appliance. We recommend that you keep this manual for future reference. Your new hob is guaranteed if used correctly it should provide you with lasting service. This guarantee is only applicable if

READ THESE INSTRUCTIONS CAREFULLY AND

COMPLETELY BEFORE USING YOUR APPLIANCE, AND KEEP IT IN A CONVENIENT PLACE FOR REFERENCE WHEN NECESSARY. THIS MANUAL IS PREPARED FOR MORE THAN ONE MODEL IN COMMON. YOUR APPLIANCE MAY NOT HAVE SOME OF THE FEATURES THAT ARE EXPLAINED IN THIS MANUAL. PAY ATTENTION TO THE EXPRESSIONS THAT HAVE FIGURES, WHIL

Important - Please read these instructions fully before installation

Customer Helpline 0345 257 7271 dangerous to alter or modify the specifications of the appliance in any way. IMPORTANT- Prior to installation, ensure that the local distribution conditions (nature of the gas and gas pressure or electricity voltage and frequency) and the

Electrical connection of your hob

- Before proceeding with the electrical connection, verify that the current carrying capacity of the system and the socket is adequate for the maximum power rating of the hob. - Electrical installation of the residence and the electrical current plug in use must be earthed and conform with safety regulations. - If there is

- For the touch controlled vitroceramic hob, the

cable must be H05VV-F 3X2,5 mm² / 60227 IEC 53. You will find the connection diagram shown on the back of your appliance. - During installation, please insure that isolated cables are used. An incorrect connection might damage your appliance. The guarantee will not cover such damages. - All repairs must be c

The mains are applied to the hob control

and all heater displays are off or a residual heat display is active. Operating-Mode B-Mode At least one heater display shows a heat setting between ´0`and ´9` Lock Mode VR-Mode The hob control is locked. Turn On and Turn Off The Appliance Select Heater - If the appli

Simultaneous operation of and buttons

The corresponding heater must be chosen with the Active/Deactive Heater Button , the Decimal Point of the related Heater Display flashes. To turn off the heater, and must be pressed at the same time. A buzzer signal sounds and ´0` appears in the heat setting display. If the timer is active for

The following safety functions are available to

avoid unintended operations of the hob control. Sensor Safety Cut Off To prevent the appliance from unwanted, random sensor operation, a sensor monitor is included. In case of one or more buttons are pressed longer than 12 sec, the sensor monitoring routine indicates acoustically that wrong operation (pot or ot

Cookware with rough bottoms such as cast iron

pans should not be used since these can scratch the glass ceramic surface. Before use, make sure that pans are clean and dry. Always place the cookware on the cooking zone before it is switched on. If possible, always place the lids on the cookware. The bottom of pans must no

Other Hob Manuals