Gaurdall Rascal Super Operation & User’s Manual

3. Setting with Circuits Open 4. Keyswitch Setting 5. Part Setting 6. Home Setting 7. Setting with Isolated Circuits 8. Unsetting 9. Unsetting after an Alarm 10. Chime Setting 11. Changing PIN 12. Reviewing the Log 13. System Test 14. System Walk Test 15. Daytime Tamper 16. Circuit Description ...

you a security system that is flexible to use and which is suitable for all domestic applications. The system comprises a main control unit which houses the main printed circuit board and power supply. The main control unit has an on board keypad for ev ...

Should the user try to set the system with the circuits open, the system will not set. The buzzer will emit a pulsed tone and the LED will flash for the open circuit. Enter the four digit PIN code or press the # to abort setting. Investigate the cause of the problem and clear the alarm. Once cleared start the setting proced ...

The part set function allows the user to set part of the system, while leaving certain circuits isolated. Enter the four digit PIN code then press the * key followed by the '0' key. The buzzer will change tone and the LED's for the isolated circuits will flash. The part guard exit time will now commence and once expired the system will par ...

On entering the premises the buzzer will emit a continuous tone. Proceed immediately to the keypad via the designated entry route and unset the system as follows. Enter the four digit PIN code within the preset entry time. The buzzer will stop and the system will revert to 'DAY' mode. If the entry time has less than 10 seconds rem ...

On entering the premises after an intrusion a full alarm condition will exist. To clear the alarm proceed immediately to the keypad via the designated entry route and proceed as follows. Insert the key and turn anticlockwise to the marking. The buzzer will emit an alternating two tone sound. The LED for the circuit w ...

With the system in the 'DAY' mode the user can review the event log. The event log is organised into 'SET' and 'UNSET' events. The log will show the first to alarm and subsequent alarms as well as isolated circuits. First to alarm is shown by the relevant LED being 'ON'. Subsequent alarms are shown by the relevant LED flashing ...

Insert the key and turn clockwise to the marking, then back to the marking. This will silence the buzzer. To reset the system and silence the two tone alternating sound and clear the tamper LED turn the key clockwise to the marking and then back to the ...

Part Home Isolate Circuit Alarm Set Set Fire PA 24 Hr Allowed Chime Installed By (Engineer Signature).................................................. Da ...