Codex VAULT 2 Administrator's Manual

USER GUIDE VAULT 2 ADMINISTRATOR GUIDE REVISION 06.08.2013 ...

Safety Warnings Please observe any warnings and follow all instructions. Do not use this equipment near water and clean only with a dry cloth. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. Do not install near any heat sources such as radiators, hea ...

Contents Safety Warnings..........................................................................................................................................................................................2 Disclaimer................................................................................. ...

1. Introduction Welcome to this guide for the Codex Vault, a next-generation modular solution for backup, archive, and dailies production that supports a range of digital camera systems. Software version - this guide assumes the Vault is running software version 2013.r1.3204 or higher. An Administrator ...

3. Product Elevations Top Elevation Showing touchscreen interface and LED Status ring. Right Elevation Sony AXSM Capture/Transfer Drive REDMAG Process Module ____ Storage Module ____ Archive Module ____ Base ____ ...

Front Elevation 4. Modules There are several modules that can be used to build a Vault system. These are: • Process module – depending on the configuration this allows loading of various media such as Codex Datapacks, Capture/Transfer Drives, SxS cards, AXSM cards, RED mags and SSDs. • Storage ...

6. Starting Up With a power source connected press the Power Button on the side of the Vault. The Vault takes around 1 minute to start up during which time you will see the Initialising screen: When it has finished initialising you will be presented with the Logon screen. 7. Logging In When the Vault i ...

8. Loading and unloading media Following the correct procedures for loading and unloading media is very important. Failure to do so may result in damage to the media and/or compromise data integrity. WARNING: Do not unload media when it is reading or writing. ...

8.1 Onboard Datapack Loading – gently insert the Datapack fully into the port. The loading process will begin, and during this time the LED on the Datapack will flash orange. When the Datapack has loaded the LED will flash green. Reading/Writing – the LED will be solid green when reading/writing. ...