Danfoss DHP-S&DP Installation Instructions Manual

ice, Danfoss A/Sliability according to the applicable warranty is not binding. Danfoss A/S retains the right to make changes to com- ponents and specifications without prior notice. © 2010 Copyright Danfoss A/S. The Swedish language is used for the original instructions. Other languages ar ...

1.1 Introduction..................................................................................... 3 1.2 Symbols............................................................................................. 3 1.3 Terminology............................. ...

1.1 Introduction The installation instructions start by describing heat pump data. The installation instructions later give instructions in a logical order covering unpacking, installation procedure, and checking the installation. References to chapters and sections within the instructions are in italics, e.g.: About the instructions ...

2 Important information Caution! The heat pump must be located in a frost-free environment! Caution! The installation may only be commissioned if the heating system is filled and bled. Otherwise the circulation pump can be damaged. Caution! If the electrician wishes to test his connections before the above is carried ...

This gas can be detected by its odour even at concentrations below its permitted levels. Evacuate the area until it has been sufficiently ventilated. Warning! Risk of personal injury! Anyone with symptoms of poisoning from the vapour must immediately mo ...

of vibrations. However, installation should not be too rigid and the pipe clamp must not be too tight. Figure 1. Do not twist the flexible hoses as they are installed. At threaded connections, use a counterhold spanner Figure 2. Cut the hose to the c ...

(or similar material) compresses 1 to 2 mm under vibration. It is not recommended to suspend the pipes from too many points, as the force at each mounting is then not sufficient. Figure 5. Elastic pipe suspension. • If the heat pump is ...

power supply must be isolated before electrical installation is started. The heat pump is internally connected at the factory. 8 – Installation instructions VMIFJ102 ...