Easymount EMS-650 Product Instruction Manual

Easymount Sign Laminator EMS-650 The Easymount Sign has been designed to be user friendly, however we strongly recommend you take a few minutes to read through this manual to ensure correct operation. Keep this manual safe for future reference. ...

Page 4 - Safety Instructions and environmental requirements Page 5 - Control panel and specifications Page 6 - Operating instructions Page 7 - Cleaning and maintenance of the system & Spare parts Page 8 - Warranty ...

knob Core adaptor Roll shaft Introduction Thank you for purchasing the Easymount® Sign laminator. This Easymount® Sign laminator is designed to perform and built to last, with its solid heavy duty construction. The advanced features allow you to laminate and mount. Mount prints onto boards and apply vinyls, tapes and adhesive films quick and easily. Please read these instructions carefully before starting to use the system to ensure you get the best results and are competent at operation. Should you experience any problems please c ...

rated working voltages before operating the machine • The power supply should be close to the system for convenient use • The power supply should provide reliable protective earthing connection • Before the operation, the electric outlet must be grounded correctly • This system must be earthed reliably to ensure the safety of the system during operation • Only the operators of this system should operate the electric or motion components/controls • Please don’t use damaged wires or sockets • Please keep children away from touching and o ...

650mm Max. Laminating Thickness 15mm Laminating Speed 5m/min Rated Working Voltage/Frequency 220V-240V, 50Hz-60Hz Rate Input Power 50W Dimensions 850 x 300 x 470mm Gross Machine Weight 33Kg Specifications Easymount EMS-650 ...

• AUTO: In auto control mode the rollers will stop immediately when the photocell is interrupted. A beep will sound if there is a blockage between the photocell sensor. Once the blockage is removed and you have activated the reset switch, the rollers will begin to run again. • FOOT: In foot control mode a beep will sound when the photocell is interrupted, but the rollers will keep on running at the minimum speed as long as the foot pedal is still engaged. Operating Instructions PREPARATION Connecting the power source: • Insert the plug into the power socket that is grounded correctly. • Turn on the powe ...

the pressure control clockwise will increase the pressure. Turning the control anti-clockwise will decrease the pressure. To adjust to the optimum pressure, increase the pressure a little more whilst the two rubber rollers are parallel and have gripped the document lightly. NOTE. Too high pressure may produce air bubbles. • Select AUTO or FOOT on the control panel. • Turn the speed adjusting control to the desired speed. • Place the document onto the feed table. Check the roller gap to suit your document. Select FORWARD t ...

IMPORTANT INFORMATION Your Easymount Sign laminator should reach you in perfect condition and is guaranteed for 1 Year from date of purchase covering defective parts and general wear and tear, this does not cover film jams, misfeeds or other operator related errors, which would be chargeable. Your Easymount Sign Laminator rollers are covered against manufacturing defects. It does not cover against any damages caused by misuse i.e. being cut with a knife or damage from non Laminating or Mounting processes. Your warranty will be void if the system has been modified by a third party not approved by the manufacturer (Vivid Lamina ...