Creek Audio EVOLUTION 100A Instruction Manual

Text of the manual

Thank you for purchasing a Creek Audio EVOLUTION 100A Integrated Amplifier. You are

now in possession of a State of the Art performance product. The functions and operation of this integrated amplifier are simple, however, the following notes are provided to explain all aspects of its design and use. For simplicity we will now refer to the amplifier as the �

INPUT AND OUTPUT CONNECTIONS

On the rear panel there are 5 Line level* inputs labelled 1-5. Inputs 3 and 4 can be config- ured for different requirements and these options are described below. Input configuration is controlled by a special menu which is available only during power-up, please see the section below. *Line level refers to a standardised way of

Line 5 is suitable for any line level source, such as CD, tuner, Tape, etc.

Line 5 is mounted on a removable expansion port that allows for two optional upgrade paths: In place of Line 5, it is possible to fit an AMBIT Tuner, or RUBY DAC, which can be installed by your dealer. Pre-out is an output signal that duplicates the signal to the 100A’s internal po

ADDING THE INTERNAL PHONO STAGE OPTION

For added flexibility, the Line 1 input on the EVOLUTION 100A can be used either for vinyl disc (Phono) or line level. To listen to vinyl discs through the EVOLUTION 100A, it is nec- essary to fit the optional Creek plug-in – ‘Sequel Phono’ board. Check with your dealer for which version (MM40, MM 48 or MC54) suit

OPERATING THE EVOLUTION 50A

The front panel controls, from left to right, feature a rotary Input selector knob, a group of 4 buttons marked SRC, PRE, TUNE, and BAND for the tuner, if fitted. Next is the OLED display window, then 4 more buttons marked TONE, MENU, BAL and INFO. The volume control, headphone socket and Power on/off switch complete the line-up.

Display Settings -

Always On The OLED display will be lit at all times the product is operating Auto Off The OLED display will go out after a short delay Display Brightness - Full Maximum screen brightness Medium Low Lowest screen brightness Headphone Switch - Disable Speakers Inserting a headphone jack will mute the loudspeaker outputs Simultaneous Use Both

The loudspeakers will be re-connected after a short delay and only if the fault has been

cleared. Over temperature If the 100A has over-heated, it may indicate the top of the case is not properly ventilated. If so, make sure the amplifier is not located inside a cupboard or placed under other equip- ment. It may also mean the amplifier has been driving low

The 100A’s remote control handset allows the user to

operate the amp and CD/DAC/Pre and tuner functions. It should be noted that the EVO remote handset will only operate Creek’s EVOLUTION 50 and 100 ranges of products and is not able to switch the mains power on or off. The operation of the remote is designed to be intuitive. However, to s

Other Amplifier Manuals