Centurion POLOphone Installation Manual

SYSTEM OVERVIEW & OPERATION The Centurion Polophone is a very versatile intercom system designed for a multitude of applications ranging from a basic 1 to 1 kit to larger installations with up to 5 components in the system. A component is either an entry panel or a handset as detailed below. Expandability The Polophone system can ...

Polophone Intercom - Page 3 Operation When setting up the system the handsets can be split into two groups. Each call button at an entry panel will be linked to a handset group. Intercommunication can only occur between these handset groups. When the call button(s) at an entry panel is pressed it will ring the handset(s) linked to ...

SPECIFICATIONS Operating Voltage Current Draw Quiescent Maximum Speech Volume Wiring / Cabling Ring tone 12-14V DC (14V DC if powering handset) Supplied from gate motor DC supply* or separate 14V DC supply Adjustable at each entry panel and handset 150mA (+/- 60mA for a 1:1 system) 200mA 2 polarized wires for speech, call and gate ...

! Component 1-Entry Panel (with one or two call buttons) consisting of: ! Component 2 -Handset consisting of: ! Component 3-Optional SYSTEM COMPONENTS Polophone Intercom - Page 5 1 X 14V DC Power supply/mains adapter(2 pin) (Alternatively use auxiliary 12V supply from gate motor) 2 X Rawlplugs 2 X ...

POWER SUPPLY & WIRING Power Supply The Polophone system operates off a 14V DC supply. The system is designed so that power can be connected to any one of the components in the system. If the system is being installed with a gate operator that can provide at least a 12V DC 150mA supply, the entry panel can be connected directly to ...

WIRING Fig 3 Cable Thickness Schedule 2 WIRES 0,2mm² 0,4mm² 0,4mm² 0,8mm² 2 WIRES PSU 12V DC PSU 14V DC LOCATION OF POWER SUPPLY LOCATION OF POWER SUPPLY FROM COMPONENT TO COMPONENT NUMBER OF WIRES CABLE DISTANCE <150M <100M Door Lock Drive Door Lock Drive Fig 4 Door Lock Drive Polophone Intercom - Page 7 WIRING Fig 3 Cable ...

1.6m ! ! ! Position entry panel on wall adjacent to entrance gate or door Mount at a height that allows speaking into the system to be comfortable. A recommended height is shown. . 1A ! Dimensions of the entry panel base and mounting holes relative to the entry panel cover. 1B Alternatively mount the entry panel onto a gooseneck ensur ...

using the slots provided in the mounting holes, adjust the base to be perfectly vertical. ! (B) Ensure that sealing washer is fitted and closes off the mounting hole against water ingress. 9 10 X Mr r Y M 12 11 13 14 ! Hook the electronics module into the base as shown and clip back into position. ! Term ...

holes in the cradle base relative to the cradle base. ! Hold the cradle base against the wall at the required height and ensure that it is vertical. ! Mark the location of the mounting ...