Audiolab 8000Q User Instructions

Text of Audiolab 8000Q User Instructions

Ermine Business Park,

Huntingdon PE29 6XU Tel: 01480 447700 Fax: 01480 431767 8000P 8000M 8000Q

Audiolab or its authorised agents or distributors.

Audiolab limited warranty ! Products not purchased from an Audiolab authorised dealer. Audiolab Ltd. warrants this product, subject to the terms and ! Products that were not new at the time of original purchase. conditions below, to be free from defects in materials and ! Products sold 'as is', 'as seen' or 'with all faults'. workmanship. During the warranty period Audiolab will repair or Repai

Mains supply and safety

Mains Supply: The mains voltage of Audiolab units is shown on the rear panel. If this does not match the voltage in your area, consult your dealer. The mains supply fuse is on the rear panel. If it has broken, check for any obvious cause before replacing the fuse with one of the correct rating and type. The fuses for all areas are type T (time lag ) AL 20mm. The fuse values are: 8000Q: 220-240V: 1.0A 100-120V: 1.6A 8000M: 220-240V

Press to raise or lower the volume. The

VOLUME control on the front panel turns. Gain Switch Unpacking This enables you to operate the volume control over a wide area Unpack the product fully. The carton should contain while minimising noise. For initial installations, set gain to 9dB. ( The Audiolab 8000Q REDUCE Gain: high sensitivity loudspeakers, low level listening. ( One IEC power cord suitable for your area INCREASE Gain: low se

3a: Connections- 8000Q

3b: Connections- 8000P & 8000M 8000Q Connections CD, TUNER, AUX, VIDEO IN, TAPE 1 IN, TAPE 2 IN The six inputs may be used for connecting any line level source. VIDEO OUT, TAPE 1 OUT, TAPE 2 OUT Three sets of record outputs for connection of up to three stereo audio recorders, e.g. tape recorder, CD recorder, audio recording input of VCR ,DVD, MP3, MiniDisc recorder, etc. PRE-AMP OUT 1 & 2 Low impedance (100 ohm) pre-amplifier output

Switch power off when connecting loudspeakers.

Use good quality low resistance loudspeaker cable. Connect the Positive RED (+) terminal of the amplifier to the Positive (+) RED terminal of the loudspeaker. Connect the Negative (-) BLACK terminals similarly. Tighten the loudspeaker terminals securely by hand. Make there are no loose strands of wire which could cause shorts. When bi-wiring loudspeakers, make sure you remove the straps

Audiolab Amplifier Owners Instructions: