AWS H-110 Operation & User’s Manual

H-110 (110lb x 0.05lb) User Manual H-110 Copyright © 2010 American Weigh Scales, Inc. All rights reserved. Rev. 3.0 ...

scale. Please read all operating instructions carefully before use. Scales are precision measuring devices and should always be handled with proper care. To ensure years of reliable service, keep these simple tips in mind: • Do not exceed the scale’s maximum capacity. Overloading your scale can permanently damage it! • Avoid exposure to extreme heat or cold. Scales perform best at normal room temperature. If temperatures have changed dramatically, calibration and adjustment may be necessary. • Allow your scale to warm up for 30-60 seconds before performing calibration and adjustment(if av ...

1. Scale 2. CR2032 Batteries (x2) II. Key Description III. Battery Installation 1. Turn the battery cover counterclockwise to open. Gently tap the back against your hand to release the batteries and cover. 2. If you are replacing the batteries, make sure the flat side (positive side) of the CR2032 battery faces out when installing. Hold Key Tare Key On/Off Key Set Key - + Install batteries positive side facing out ...

2. Once the start-up process completes and the scale goes to zero you are ready to weigh. 3. Place the quantity to be weighed on the end of the hook. 4. Wait a couple seconds for the display to stabilize before taking a weight reading. For best results, hang scale from a fixed point rather than holding by hand. V. Changing the Unit of Measure 1. Press the SET key to change the scales displayed unit of measure. 2. If the scale is turned off then back on, it will default to the last unit used. • H-110 Units: kg (kilogram) lb (pound) lb:oz (pound:ounce) VI. Using the Tare Feature ...

the contents. 4. To return to normal weight display (gross weight), remove any items from the weighing platform and press the TARE key again to re-zero the scale. VII. Using the Hold Feature 1. To hold the current weight on the display, press the HOLD key. 2. To return to normal weighing, press the HOLD key again. VIII. Calibration Calibration and adjustment are performed at the factory. However, the weighing range can shift slightly during shipping. Also, due to changes in local acceleration of gravity around the world, adjustment is recommended when moving the scale from one location to another. ...

required calibration weight. 4. Place the weight on the end of the hook and press ON/OFF when the weight is stable. 5. The display will show PASS and return to normal weighing. If EEEE is displayed, try calibration again. X. Troubleshooting • Problem: Scale will not turn on • Solution: Check the batteries • Problem: Displayed weight fluctuates randomly • Solution: Make sure your workspace is stable and free of any air currents or vibration • Problem: Displayed weight is inaccurate • Solution: Perform a calibration adjustment XI. Error Codes 1. OUTZ - Zero range has shifted. ...

Power Two (2) CR2032 Batteries Operating Temp 50°F - 86°F Dimensions 1.0 x 2.5 x 5.2 in. Warranty 10 Year Limited Warranty XIII. Capacity/Readability Charts H-110 110lb x 0.05lb 50kg x 20g 110lb x 1oz ...