Axis YP3040 Installation Manual

Text of the manual

About this Document

This document includes instructions for installing the YP3040 Pan-Tilt Motor. Legal Considerations Video and audio surveillance can be prohibited by laws that vary from country to country. Check the laws in your local region before using this product for surveillance purposes. Electromagnetic Compatibility (EMC) If use of this equipment c

YP3040 Installation Guide

Page 3 ENGLISH YP3040 Installation Guide This installation guide provides instructions for installing the YP3040 Pan-Tilt Motor. Installation steps 1. Check the package contents against the list below. 2. Hardware overview. See page 4. 3. Install the hardware. • Install the wall bracket, see page 5. • Install the Pan-Tilt motor,

YP3040 Installation Guide

Hardware overview Note: For functions behind the side panel, refer to About the DIP switch settings, on page 9 Mounting screw (4x) PTZ control cable Splint Brace Mounting base Power supply cable Wall bracket RS-485 (recommended accessory) Side panel 24 V AC Brace axis Direction of tilt Rear Front

YP3040 Installation Guide

Page 5 ENGLISH Install the hardware Install the wall bracket 1. Prepare the wall for installation of the wall bracket (recommended accessory), use the supplied drill template to position the holes. Make sure to use drill bits, screws, and plugs that are appropriate for the material. 2. Pull the cables through the wall bracket, see i

YP3040 Installation Guide

Splint dimensions Connect the cables 1. Connect the power supply to the pan-tilt motor according to the Installation Guide supplied with the mains adaptor. The recommended mains adaptor is AXIS PS24 Mains Adaptor. For more information on this product, see the Axis web site at www.axis.com 2. Connect the PTZ control cable to t

YP3040 Installation Guide

Page 7 ENGLISH Setup When you install a compatible Axis network camera on the YP3040 Pan-Tilt Motor, the controls will be available from the Live View page in the camera’s web pages after enabling the PTZ functionality in Setup tools. Follow these instructions to enable PTZ functionality in the camera: 1. Go to Setup > System Opti

YP3040 Installation Guide

Technical specifications Troubleshooting Unit Function Description YP3040 Input voltage 24 V AC 50/60 Hz Power consumption 30 VA Movement range Pan 0° to 355° Tilt 10° to -80° Movement speed Pan 7.5°/s Tilt 6°/s Protocol (default) Pelco-D Bit rate (default) 2400 bps Address (default) 1 Operating temperature -20°C to 6

YP3040 Installation Guide

Page 9 ENGLISH About the DIP switch settings The transmission between the motor and the camera will not work if the camera uses a different protocol and bit rate than the motor. For cameras with a different protocol than the Pelco-D and bit rate of 2400 bps, the dip switches must be changed, see Change the DIP switch settings, on pa

YP3040 Installation Guide

Change the DIP switch settings 1. Loosen the 4 side panel mounting screws and remove the side panel. 2. Set the 8 switches to select functions. Switches 1, 2, 3, and 4 are used to select the PTZ control protocol. Switch 7 is always OFF. Switch 8 is used to connect a terminal resistance of 120 Ω, switch to ON when required.

Other Camera Accessories Manuals