Barracuda Networks F10 Installation Manual

www.barracuda.com vF10b-120321-03-0321 All rights reserved. Use of this product and this manual is subject to license. Information in this document is subject to change without notice. Trademarks Barracuda NG Firewall is a trademark of Barracud ...

About this Manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Warranty Note . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

General Introduction The information in this user guide has been carefully reviewed and is believed to be accurate. It is valid for Barracuda NG Firewall firmware versions 5.0.4 and later but not 5.2.0 and 5.2.1. Barracuda Networks assumes no responsibility for any inaccuracies that may be contained in this document. This manual may ...

Safety Instructions The following information relates to the safety of installation and maintenance personnel. Read and follow all instructions before attempting to unpack, install or operate this equipment, especially before connecting the power adapter. Electrical Safety Basic electrical safety precautions should be followe ...

• Remove any jewelry or metal objects from your body, which are excellent metal conductors that can create short circuits and harm you if they come into contact with printed circuit boards or areas where power is present. ESD Precautions Electrostatic discharge (ESD) is generated by two objects with different electrical charges comi ...

Introduction and Package Contents Your new Barracuda NG Firewall F10 Rev. B is an integrated security appliance preinstalled with Barracuda NG Firewall firmware. This winning combination offers a ready to run security solution that is flexible, affordable and easy to deploy. Hardware Configuration Table 1 F10 Rev. B Hardware ...

Inspecting the Package The following items are included in the package: • One security appliance • One power cord • One power supply • One ethernet crossover cable (red) • One ethernet standard cable (grey) • One serial cable (console) • Printed Quick Start Guide • One USB flash drive including documentat ...

Powering Up and Down This chapter describes the procedure used to install your appliance and perform the initial configuration. Powering Up the Appliance • Connect and power on the appliance. The power LED indicates green. • You may use the serial console to monitor the booting procedure. • After a few seconds, the boot ...

The Status LED Your appliance is equipped with a variety of LEDs. One of them is the Status LED. It is either labeled with a heart symbol or the term Status. It indicates the appliance’s operational state by changing colors between green, orange and red and by changing between blinking and steady glowing. The table below shows the ...