BBK ABS730X Service Manual
Text of the manual
1. SAFETY PRECAUTIONS
1
2. PREVENTION OF ELECTRO STATIC DISCHARGE(ESD)TO ELECTROSTATICALLY
SENSITIVE(ES)DEVICES
1
4. PREVERTION OF STATIC ELECTRICITY DISCHARGE
3
5. ASSEMBLING AND DISASSEMBLING THE MECHANISM UNIT
4
5.1 OPTICAL PICKUP UNIT EXPLOSED VIEW AND PART LIST
5
6. ELECTRICAL CONFIRMATION
6
6.1 V
1.1 GENERAL GUIDELINES
1. When servicing, observe the original lead dress. if a short circuit is found, replace all parts which have
been overheated or damaged by the short circuit.
2. After servicing, see to it that all the protective devices such as insulation barrier, insulation papers
shields are properly installed.
3. After servicing, make the followin
AUDIO IN 1 button
4
2
Headphone jack
Echo button
OPEN/CLOSE button
TONE button
VOL +/- button
EQ button
SF button
TIMER button
CLOCK button
MIC 1 jack
3
Audio in 1
7
MIC 2 jack
AUDIO IN 2 button
10
PSM button
Power switch
12
22
16
26
11
21
15
25
9
13
23
17
27
19
29
IR sensor
FW D button
STOP button
PLAY button
PAUSE button
REW but
The laser diode in the traverse unit (optical pickup)may brake down due to static electricity of clothes or human
body. Use due caution to electrostatic breakdown when servicing and handling the laser diode.
4.1.Grounding for electrostatic breakdown prevention
Some devices such as the DVD player use the optical pickup(laser diode)and the optical pickup will
5.1 Optical pickup unit explosed view and partlist
1 Upper cover
2 Power amplifier PCB
3 Left bracket of heat radiator
4 Backing plate
5 Display PCB
6 Front panel PCB
7 Left function button
8 Number button
9 PCB bracket
10 Bracket of uppe
5.2.1 Protection of the LD(Laser diode)
Short the parts of LD circuit pattern by soldering.
5.2.2 Cautions on assembly and adjustment
Make sure that the workbenches,jigs,tips,tips of soldering irons and measuring instruments are
grounded,and that personnel wear wrist straps for ground.
Open the LD short lands
6.1. Video Output (Luminance Signal) Confirmation
DO this confirmation after replacing a P.C.B.
Purpose:To maintain video signal output compatibility.
1.Connect the oscilloscope to the video output terminal and terminate at 75 ohms.
2.Confirm that luminance signal(Y+S)level is 1000mVp-p±30mV
Measurement point
Video output terminal
Color bar 75%
PLAY(Ti