Bewator KC 5000 Technical Manual

Text of the manual

Copyright © February 2002 Bewator AB, Solna Sweden.

Material from the KC5000 Technical manual may only be copied with the consent in writing of Bewator. Bewator reserves the right to alter both the content of the manual and the design of the product. Document number: 80728-2 Bewator AB is part of Bewator Group, which develops and markets a complete security

KC5000 Technical manual — Contents

3 Contents KC5000 THE INTELLIGENT CODE LOCK ................................................................4 How to use...............................................................................................................................4 Printouts.................................................................

KC5000 Technical manual — Introduction

KC5000 the intelligent code lock KC 5000 is a code lock system for up to six doors. With a capacity of 99 codes and a built in timer with 99 time zones, which can be unique for different doors, enables to handle different access levels for different groups. For example can the postman’s code be limited to be valid

KC5000 Technical manual — Introduction

5 System components KC5000 consists of the following equipment: • Central unit. In the central unit all data for the system is programmed and stored. • Keypad M65. Up to 6 keypads can be connected (one at each door). • Power supply. 24 V AC included in delivery. • Printer. As an extra accessory a printer can b

KC5000 Technical manual — Installation

Installation This chapter describes how to install KC 5000. Placing and mounting Central unit The central unit is designed for wall mounting (there are three screw holes in the back plate), in a secure room with normal temperature, e.g. the building’s power room. Place the power supply near the central unit. Keypa

KC5000 Technical manual — Installation

7 Before starting to install the system At the back of the manual are three charts. Make copies of the charts and ask the system manager to fill them in according to the instructions in the chapter Preparations. Connecting up To connect the different components in the code lock system, proceed as follows: (see wiring

KC5000 Technical manual — Installation

Connecting the KC5000 The diagram below shows how to connect the keypad to the central unit, the electric lock and the exit request button, and also where the power supply, telephone line and printer (if any) should be connected. ON OFF M65 1 2 3 4 5 PL 1 LINE CARD KC5000 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 1

Other Door locks Manuals