Bewator PD30EM Installation & User Manual

Text of the manual

Book contents English................................................ 3 Svenska..............................................17 Deutsch..............................................31 Français..............................................45

PD30EM & PD40EM Installation and User manual

 ENG English Copyright © 2006 Bewator AB, Solna. Material from this manual may only be copied with the consent in writing of Bewator. Bewator reserves the right to alter both the content of the manual and the design of the product. Document number: 81618-9 Bewator AB develops and markets a complete security prod

PD30EM & PD40EM Installation and User manual

ENG Contents About this manual................................................................5 ProxCodoor - General...........................................................5 Supplied material........................................................... 6 Addressing...............................................

PD30EM & PD40EM Installation and User manual

 ENG About this manual This manual covers both the Scandinavian style (PD30EM) and the International style (PD40EM) of the ProxCodoor. In the scope of this manual we will use the name ProxCodoor (unless notified.) ProxCodoor - General The ProxCodoor is a system component in the Bewator Entro Access Control system

PD30EM & PD40EM Installation and User manual

ENG Supplied material The ProxCodoor kit consists of the following parts: The ProxCodoor unit with integrated proximity reader and 20 cm cable (with connector matching the long cable). Dropbox for connection to Entro. 5 metre cable with a 4-pin connector and a free end to be connected to the dropbox. Extension s

PD30EM & PD40EM Installation and User manual

 ENG PD30EM installation Remove the cylinder ring and the door handle from the door by loosening the four screws. See photo . The lever handle spindle should project no more than 20 mm on the outside of the door. If the spindle is too long, push it through into the handle on the inside. If this cannot be done,

PD30EM & PD40EM Installation and User manual

ENG Disassemble the lockcase from the door and cutout enough space for the cable entry at the bottom of the hole inside the handle. Also be sure there is space to finally feed the cable connector (and some remaining cable) beneath the lockcase. See figure . ! PD30EM Figure  Install the cable from the lock

Other Lock Manuals