ATX Flexnet Series Installation & Operation Manuals

Specifications subject to change without notice. ...

i TABLE OF CONTENTS Page 1. SYSTEM OVERVIEW.................................................................................................................................1-1 1.1. System Features........................................................................ ...

7.18. SNMP Menu.......................................................................................................................................7-8 7.19. Port Access Control Enable/Disable........................................................................ ...

1-1 CHAPTER 1: SYSTEM OVERVIEW SYSTEM OVERVIEW 1. System Overview Thank you for purchasing an FNER Expandable Routing Switch. FLEXNET’s FNER series switches are based on the same technology as our popular FNEM Series Modular Programmable RF Switches. They were deve ...

CHAPTER 1: SYSTEM OVERVIEW Figure 1: MCP 128 (8x1) Controller 1.5.2 FNER Switching Module The FNER Switching Module is a 16x1 unit that utilizes solid state switching elements to provide seamless switching speeds (nanoseconds). Up to eight switching modules may b ...

2-1 CHAPTER 2: CONNECTIONS & PROTOCOLS CONNECTIONS & PROTOCOLS 2. Connections & Protocols 2.1 AC Connections All AC power cords are included with your system when it is shipped. If using an AC power cord that is not FLEXNET, make sure it is shielded and has a grounding ...

CHAPTER 2: CONNECTIONS & PROTOCOLS 3 RXD (receive data) Non-inverting Transmit 4 DTR (data terminal ready) Non-inverting Receive 5 GND (signal gound) GND 6 DSR (data set ready) Inverting Transmit 7 CTS (clear to send) Not used 8 RTS (request to send) Not used 9 Not ...

2-3 CHAPTER 2: CONNECTIONS & PROTOCOLS Note that the maximum control cable length that can exist between FNER modules is 6 feet. Refer to the appendix for proper control port conections. 2.5 Ethernet Port The MPC 128 has the ability to communicate over Ethernet. The sy ...

CHAPTER 2: CONNECTIONS & PROTOCOLS This page left intentionally blank. ...