Alfano ADSMAG Manual 

ADSMAG Manual (EN) Firmware 0.1 Serial Be preserved 1 0 0 0 ...

INSTALLATION • It consists of 6 LEDs, 4 buttons, the external dimensions are 133,5x90x40mm, weight 275gr. • The ADSMAG is equipped with a magnetic sensor ref. A1301 • Batteries : Type 2xAA The four LEDs above the screen are activated by running the fastest time achieved. The two ...

Power On Press the button on the bottom right, the system is activated on the main page. Backlight Depending on the setting in the SETUP DISPLAY, the Alfano is active in several ways : • "OFF" : Alfano the comes on without backlight. • "MAN" : the Alfano activates the backlight : o ...

Turn Off From the main page, press the button on the bottom right. CIRCUIT, Configuration From the main page, press the button on the bottom left. For the visualization and the logical recording of the data, it is necessary, before using the ALFANO in race, to configure the morphology ...

Press the arrow above to add a second magnetic stripe. Press the arrow above to add a third magnetic stripe. Press the arrow down to select the starting point of the timing of the second magnetic strip, then press on « OK » to finish the configuration of the circuit. Note : this c ...

Press Setup to set the maintenance of the lap time, the brightness of the backlight and LED. Each "Layout" is numbered to facilitate the choice, this figure with the word «Confirm» appears only a few seconds. Press the button « Confirm » to choose, even if this word is no longer ...

Race « 4 » • Lap time • Nr of laps • Difference on the lap Race « 5 » • Lap time • Nr of partial • Difference on the lap Race « 6 » • Lap time • Nr of laps Race « 7 » • Lap time (REVERSE) • Nr of laps • Difference Race « 8 » • Lap time with partial ACC ...

Race « 9 » • Lap time • BEST lap • Times of partial • Nr of laps • Nr of partial • Difference on the lap • Difference on partial Race « 10 » • Lap time • BEST lap • Times of partial • Nr of laps • Nr of partial • Difference on the lap • Difference on par ...

Start a timing session and use the Alfano in race Start a timing session Upon detection of the start line, the system displays window race, timing and recording starts. To change the window in race Then press the button at the top right. To enable or disable the backlight in the race P ...

To close the session Press the button on the botton left or botton right. STOP appears for a few seconds. Best laps Before returning to the main page, the ALFANO shows the best time and the best time of the last session ...