ACTi CAM-6200 Quick Installation Manual

Quick Installation Guide Ver. 061031 Model: CAM-6200/6220 ...

All the safety and operating instructions should be read before the product is operated. 2. Heed all warnings All warnings on the product and in the instruction manual should be adhered to. The symbol indicates the following items, please carefully read the description next to each symbol. a. Failure to follo ...

FCC/CE Regulation NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment ...

0 PRECAUTIONS................................................................................................ 0-1 Copyright .....................................................................................................................................0-1 Trademarks .................................................................. ...

2.2.1 Open Streaming Activator...........................................................................................2-15 2.2.2 Click Setup. ..................................................................................................... ...

dome. Follow the description below to connect to respective apparatus. 1.1.1 Indoor connections 1. Analog Video-out connector Connect it to the video-in port of respective apparatus. The signal is 75Ω Composite Video Signal. 2. DC jack-in for power inp ...

WAN port is for FTTH and connects to an xDSL or cable modem. 1.1.2 Outdoor connections 1. Analog Video-out connector Connect it to the video-in port of respective apparatus. The signal is 75Ω Composite Video Signal. 2. Power input Connect this DC jack to the power supply of 110VAC or 23 ...

Follow the description below setup IP speed dome’s hardware camera ID, baud rate and protocol. Speed dome setup Video platform setup AP (Streaming Activator) setup Camera ID, baud rate and protocol setting in these 3 item should be the same for PTZ control function to work. 1.2.1 Setup camera ID, baud rate and protocol Loosen the f ...

SW9 SW10 PELCO D-2400 OFF OFF PELCO P-4800 ON OFF PELCO P-9600 (Recommended) OFF ON EYEVIEW ON ON z Camera ID address setting Please refer to the Appendix. A “Camera hardware ID setup” ...

1.3.1 Punching a hole in the ceiling Remove the target ceiling first, then attach the hole-sticker supplied with the camera to the ceiling and make the desired hole accordingly with a proper tool. 1.3.2 Take out the camera 1.3.3 Fit the upper casing into the ceiling as shown below. 1.3.4 Screw the screws securely to ensure the cam ...