ACTOP VDP311 Operation & User’s Manual

1. Monitor Unit Description The VDP311 system is a flexible and user-friendly system that allows a number of monitors to be used with a number of door units with cameras. The monitors allow visibility of the callers via the camera in the door units and, when used with the optional electronic lock, enable the resident to electronically open the doo ...

2. Wall Mounting Fix the mounting bracket to the wall first using the fixing holes (2), then connect wiring and finally hook the monitor unit over the hooks (1) on the bracket 3. Electrical Connections The connections between the Door Unit (left) and the Monitor (right) are made using 4-wire cable as shown below. If you add an additional monitor y ...

You can use any 4-core cable to make these connections, but screened and/or armoured cables are most secure. To connect additional monitors you will need to use 5-core cables to prevent interference between the monitors – only the monitor that accepts the call will be in communication with the caller. It is possible to use 4-cores for the signal ...

4. Operation Caller at Door 1. Caller presses the Call button on the Door Camera 2. Both the monitor and the Door Camera will play the selected ring tone and the Activity LED will light on the monitor 3. The camera will turn on and the image of the caller will be displayed on the Monitor screen 4. Press the Call button on the monitor to accept the ...

5. Door Camera 2 1 3 4 5 6 7 FRONT VIEW 1. Fixing hole (connects to mounting bracket) 2. Microphone 3. Camera 4. Light sensor (controls the infra-red) 5. Call button 6. Speaker 7. Fixing hole 2 1 3 2 4 5 6 REAR VIEW 1. Fixing holes on bracket 2. Connection to main unit 3. Space in bracket for wires etc. 4. Electronic lock connection terminals (+ve ...

6. Technical Specification • Monitor dimensions: 230mm x 165mm x 35mm • Camera dimensions: 150mm x 120mm x 30mm • LCD on monitor: 7inch diagonal, TFT technology • Image sensor on camera: 1/3” CMOS, 1440 x 234 effective pixels • Audio and video communication between monitor and camera (video from camera to monitor only) • Infra-red ni ...

• The strike plate should be mounted on the door frame with the bolt passing centrally. The roller, which helps release the bolt, passes directly over the bump at the top (or bottom if mounted on left) on the striker plate • A 2-core wire is required to be fitted from the Door camera unit to the lock. • The button on the inside of the door a ...