Russound DPA-1.2 Instruction Manual

DPA-1.2 Tested to Comply with FCC Standards Conforms to UL 6500 Certified to CSA C22.2 No1-94 68835 DPA-1.2 NEWMARKET, NH USA DESIGNED IN THE USA MADE IN TAIWAN SERIAL # POWER Russound FOR HOME OR OFFICE USE DPA-1.2 Tested to Comply with FCC Standards Conforms to UL 6500 Certified to CSA C22.2 No1-94 68835 DPA-1.2 NEWMARKET, NH USA DESIGNED IN THE USA MADE IN TAIWAN Instruction Manual 2 Channel Amplifi ...

“WARNING” “ TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.” “CAUTION” “ TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER. NO USER - SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALI- FIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral trian- gle, is intended to alert the user to the presence of uninsulated “dangerous volta ...

the appliance should be unplugged from the outlet when left unused for a long period of time. 15. Object and Liquid Entry - Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through the openings. 16. Damage Requiring Service - The appli- ance should be serviced by qualified service personnel when: A. The power - supply cord or the plug has been damaged; or B. Objects have ...

two-channel amplifier. The DPA-1.2 is a high-current, high-quality amplifier, which includes automatic A/B switching. The DPA-1.2 two-channel amplifier will amplify a source at the sensing line input or the sensing speaker level input. Switching between a default audio source and a local source, the DPA-1.2 is ideally suit- ed for those applications that require automatic switc ...

12V TRIG INPUT 12V TRIG OUT 100mA STEREO VIDEO INPUT SENSING DELAY BRGD * MONO GAIN SPEAKER B OUT L R 1 2 3 4 5 AC 120V 60Hz 1.5A~ AMPLIFIED INPUT SENSING DEFAULT AMPLIFIED INPUT AVIS : RISQUE DE CHOC ELECTRIQUE – NES PAS OUVRIR. * FOR BRIDGED OPERATION SEE MANUAL L R WARNING : SHOCK HAZARD – DO NOT OPEN LEFT VIDEO LINE OUTPUTS RIGHT AMPLIFIED INPUT FROM AUDIO DISTRIBUTION SYSTEM AMPLIFIED OUTPUT TO ROOM SPEAKERS 5 ...

Power Switch: Turns on the main power for the ampli- fier. When the power is on, the LED will be illuminated. 5. BACK PANEL CONNECTIONS Line Input: This line input is a sensing input that will activate the DPA-1.2 when an audio signal is present. When there is no audio, the amplifier will go into standby or default back to the whole-house amplified signal if playing. Speaker Level Input: The speaker level input is a sensing input that will ...

amplifier output. When connected to the A or B output, either 6- ohm or 8-Ohm speakers could be used. When using both A and B speaker outputs, only speakers with impedance higher than 8 Ohms can be connected. For Bridge amplifier operation, connect the + of the speaker to the R+ and - of the speaker to the L+ of the amplifier. Mono Bridged Operation Stereo Operation 7 SPEAKER A OUT SPEAKER ...

output is 12 volts at a maximum of 100mA. This can be used to drive a relay- operated AC outlet or other 12-volt triggered devices. The 12-volt trigger input is used to activate the DPA-1.2 independently from the auto turn on sensing circuit, in which case the delay, video and audio sensing are bypassed. Delay Time: The delay timecan be adjusted from about 0.3 minutes to 8 minutes. The DPA-1.2 amplifier will automa ...

45W @ 6 Ohms. Frequency response: 20HZ to 20KHZ -0.3dB. Total harmonic distortion: 0.05% 8 Ohm .075% 6 Ohm Input sensitivity: 400mV line Input impedance: 22k Line Input Signal to noise ratio: 85dB Input trigger: 12VDC 10k Output trigger: 12VDC 100mA Auto off delay time: 2 to 10 minutes Primary fuse: T2.0A /250V Power requirements: Factory set for 120 VAC 60Hz or 230 VAC 50Hz. 2 terminal detac ...

the date of purchase against all defects in materials and workman- ship. During this period Russound will replace any defective parts and correct any defect in workmanship without charge for either parts or labor. For this warranty to apply, the unit must be installed and used according to its written instructions. If service is necessary, it must be performed by Russound. The unit ...

 603.659.5170 • Fax 603.659.5388 e-mail: [email protected] Come visit us at: ...