F5 6900 Installation Manual

Text of the manual

Installation Guide for 6900/8900 Hard Drives

i Product Version This manual applies to the platforms 6900 and 8900 created by F5 Networks, Inc. Publication Date This guide was published on October 30, 2009. Legal Notices Copyright Copyright 2009, F5 Networks, Inc. All rights reserved. F5 Networks, Inc. (F5) believes the information it furnishes to be accurate

VCCI Class A Compliance

This is a Class A product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take corrective actions. The power cables included with this platform are designed for use solely with this platform.

Replacing Hard Drives

• About the hard drives • If a hard drive fails • Replacing the primary hard drive with the spare hard drive • Creating a spare disk • Halting the system

Replacing Hard Drives

Installation Guide for 6900/8900 Hard Drives 1 About the hard drives The BIG-IP® 6900 and 8900 platforms have two removable hard drives (shown in Figure 1). You can change or replace the hard drives as part of the routine maintenance of the unit or in the event of a drive failure. Important We recommend that you back up your BIG-IP con

If a hard drive fails

The tasks you perform if you experience a hard drive failure vary, depending on the BIG-IP software version installed on your system. For version 9.x and 10.0.0 Your system cannot use the spare disk as a replacement, but if your primary disk fails, you have two options: ◆If you would like to get the system up and running while you w

Replacing Hard Drives

Installation Guide for 6900/8900 Hard Drives 3 Replacing the primary hard drive with the spare hard drive If you are running version 10.0.1 of the BIG-IP software and have previously used the sparedisk utility to copy the contents of your primary hard drive to the spare hard drive, you can move the spare hard drive to the primary hard d

8. Suspend the boot process at the GRUB boot menu by pressing the

down arrow key. 9. Select TMOS maintenance from the menu to boot into the TMOS maintenance operating system and press Enter. 10. Type the following command: tmidiag -r HD1 11. Reboot the system by typing the following command: reboot After you have replaced the primary hard drive with the sp

Other Network Hardware Manuals