Hobart FX Operation Instructions Manual

8652 0001 REV. 17.03.2008 Installation and operation Instructions FX/GX SERIES Glass and Dishwashers ...

2 Installation .............................................................................. 5 2.1 Location ......................................................................................... 5 2.2 Electrical con ...

This machine is exclusively to be used to wash ware such as plates, cups, glasses, cutlery, trays etc. Do not use for electrically heated cooking and heat conservation ­appliances. Safety Never hose down the machine. The "Attention" symbol is shown beside instructions that ...

2.1 Location Wall clearence is not required. Level machine by turning the feet. Distribute machine weight equally onto all feet. Vapour may escape from the dishwasher door. Therefore adjacent furniture has to be protected to prevent swelling. 2.2 Electrical connection Must be carried out by an authorized tech ...

Pushing this button switches the machine on. As soon as the machine is ready for operation, the wash cycle is started by pushing this button also. By pushing and holding (3 seconds) this button, the drain and self cleaning cycle starts. At the end of the cycle, the machine switches off automatically. After sw ...

Do not use any acidic detergent products with the built-in detergent pump! (The ph-value has to be higher than 7.) Place the suction hose into the detergent container. Fill the suction hose according to chapter 4.3. 4.2 Rinse aid Place the suction hose (blue marking) into the rinse aid container. Fill the suc ...

For the first run, the softener has to be filled with regeneration salt and potable water. Filling the salt reservoir with cleaning agent will damage the water softener. Open the door. Unscrew the softener lid and fill the softener with 2 kg of "Granular regeneration salt" (do not use salt tablet ...

Remove any food debris before loading plates into rack. Spray off greasy food soil. 5.2 Run Put rack into the machine and close the door. Push the ON/OFF button ➀. During the wash cycle is running, the button illuminates blue. As soon as the ON/OFF button ➀ changes to g ...

Close the door. Push and hold the ON/OFF button ➀ until the button flashes "blue". NOTE: During the drain cycle, the interior of the machine is cleaned automati- cally. A final inspection is ­recommended to remove any food debris. When the ON/OFF button goes off: Switch off main switch or unplug and close t ...