Rane DC 22 Operator's Manual

In its present form, it makes interesting and useful reading. If you run out of patience quickly, at least read this part to make sure you don’t exterminate everything within a two mile radius by doing something wrong. First, be sure the POWER switch is off. Att ...

LED may light occasionally. If the OL (overload) LED flashes, turn the output level down on the previous device. GATE THRESHOLD control sets the point at which the Input signal level causes the Gate to become active. _____________________________________________ COMPRESSOR THRESHOLD control se ...

INPUTS 1 and 2: Choose between the balanced XLR or the balanced/unbalanced ¼" TRS jacks, but only use one. Inserting a ¼" TS jack will work—however—we recommend using balanced lines, especially when connecting any cable over 10 feet (3 meters) in length. Consult the Sound System Interconnection RaneNote provided with th ...

how you cut it, this is an automatic volume control. It is a hand on a knob, turning the volume down and turning it up again. The hand is really quick and really accurate, but it’s just turning a volume control. When the input signal reaches a level set b ...

reduce peaks for overload protection. In other words, it’s a com- pressor with a maximum ratio. A compressor is used to change the dynamics for purposes of aesthetics, intelligibility, record- ing or broadcast limitations. Once the threshold of a limiter is reached, no more si ...

1. Determine the driver’s maximum continuous average power rating in watts (W) (specified by the manufacturer). 2. Determine the driver impedance “z” in ohms (specified by the manufacturer). 3. Using the data in steps (1) and (2) above, calculate the maximum signal level in dBu that the driver can handle. Max dBu ...