DFG ETitanWire Instruction Manual

Instruction Manual Provided By http://www.MyBinding.com http://www.MyBindingBlog.com DFG E-TitanWire Heavy Duty Binding Machine ...

these operating instructions and have been fully trained to operate this product. 1. Indoor use only. Do not expose to rain. 2. Keep hands, long hair, neckties, necklaces and other loose articles away from roller. 3. Do not place this product on an unstable stand, cart, or surface. The product may fall and hurt you. If you use a cart, move the product and cart carefully. 4. Do not insert objects or spill liquids into the product. They may damage the unit, or short out components that may result in fire. 5. The power outlet shall be installed near this prod ...

Dear Customer, Thank you for purchasing our ETitanWire machine. The following are basic installation and operation instructions. For advanced binding instructions, please contact DFG. Installation 1. Install binding handle 2. Connect power cord and foot switch Determine metal wire binding element size There are two methods you can use: (ETitanCoil machine shown) 1. Use coil that is 2-3 mm (1/8” ) larger than book thickness or 2. Use our wire size selector. Refer to picture (ETitanCoil machine shown) Put book on machine base, under the “Size Selector”. Move the “Size Selector” down until its bottom touches ...

1. Select the punch margin (general guideline: the thicker the book, the larger the ideal punch margin. However, you can use small punch margins for any book thickness) 2. Set side guide to center the sheet Punching 1. Align sheets and insert edge to be bound into punch throat 2. Push the sheets flush against the inner back wall of the punch throat 3. Slide the sheets leftward, against the side guide 4. Pull the punch handle to punch You can punch up to 25 sheets of paper (20 lb. paper) at once. Most people punch between 12 and 20 sheets at a time. Binding Set closing mechanism measuremen ...

loops in each individual hole. Do not miss any holes; remaining wire will quickly begin to fall into place at next holes. Fingers should come to the other side of the book easily. Moving thumb gently along top of wire, sliding hand down binding edge should easily guide all wire fingers into holes. Make sure that all wire fingers go in all punched holes, and turn coil so that fingers reach completely through book. Hold book together and lift with binding edge (and binding wire) pointed downward. Wire should rest easily and naturally in punched holes. Lower the binding edge (and wire) into wire closure mechani ...