First Isaac16 EDU Reference Manual

Text of First Isaac16 EDU Reference Manual

Innovation First, Inc.

EDU-RC & Motherboard Reference Guide 11.8.2002 www.InnovationFirst.com Page 2 Table of Contents 1. Overview ............................................................................................................................2 2. Isaac16 EDU Motherboard Layout......................................................................................4 3. POWER Input...................................................................

Innovation First, Inc.

EDU-RC & Motherboard Reference Guide 11.8.2002 www.InnovationFirst.com Page 3 The Isaac16 EDU Robot Controller takes the collected data from both the Operator Interface and the on- board sensors and then forwards it to the PBASIC program processor. The program, (PBASIC Code), takes the data, determines what to do with the outputs to make the robot behave as desired, and sets the PWM and Relay outputs to the appropriate states. The

Innovation First, Inc.

EDU-RC & Motherboard Reference Guide 11.8.2002 www.InnovationFirst.com Page 4 2. Isaac16 EDU Motherboard Layout Battery Connection: 7.2V Nominal EDU-RC Absolute Voltage Range: 5.2V to 9.0V (damage may occur above 9.0V) Table 2: Connector Pinout Information Pin Header Left Pin Center Pin(s) Right Pin +5V Output Input Signal (0-5V) Ground +Battery PWM Signal Output +Battery Ground +Battery Reverse Output Forward Output Ground In

Innovation First, Inc.

EDU-RC & Motherboard Reference Guide 11.8.2002 www.InnovationFirst.com Page 5 3. POWER Input The Power connector on the Isaac16 EDU Motherboard is intended to accept power from a 7.2V battery. The current draw for the EDU Robot Controller is typically between 0.20A to 3.0A. The maximum voltage allowable is 9.0V. Exceeding the 9.0V limit will damage voltage regulators in the EDU Robot Controller and will void the warranty. The min

Innovation First, Inc.

EDU-RC & Motherboard Reference Guide 11.8.2002 www.InnovationFirst.com Page 6 6. RELAY Outputs The Isaac16 EDU Motherboard has four 4-pin RELAY connectors (abbreviated RLY). The Relay outputs are most commonly used to drive Multi-Speed Motors. These outputs can only drive the Multi- Speed Motors in Full Forward (clockwise), Full Reverse (counter-clockwise), or Off. The Multi-Speed Motors can be connected directly to the Relay out

Innovation First, Inc.

EDU-RC & Motherboard Reference Guide 11.8.2002 www.InnovationFirst.com Page 7 7. PWM Outputs The Isaac16 EDU Motherboard has eight 4-pin PWM connectors. The PWM outputs are most commonly used to drive Multi-Speed Motors. These outputs can cause the speed to vary on the Multi- Speed Motors in a range from Full Forward, to Full Reverse, or Off. The Multi-Speed Motors can be connected directly to the PWM outputs. Be sure to connect

Innovation First, Inc.

EDU-RC & Motherboard Reference Guide 11.8.2002 www.InnovationFirst.com Page 8 8. ANALOG Inputs The analog inputs on the Isaac16 EDU Robot Controller can be used to measure various conditions on the robot and trigger automatic responses by the control (PBASIC) program. The Isaac16 EDU Motherboard has four 3-pin ANALOG connectors (abbreviated AN). Potentiometers and gyros (yaw rate sensors) may be connected to the analog inputs. Fo

First Computer Hardware Owners Instructions: