silavent SVC6 Installation Instructions Manual

Tel: +44 (0) 8443 715523 Fax: +44 (0) 8443 715524 www.polypipe.com/ventilation www.polypipe.com ...

With Timer With Humidistat, timer and pull-cord switch over-ride With Humidistat Twin speed with pull cord switch Twin speed with Humidistat and pull cord boost SVC150PB SVC150TB SVC150HTB SVC150HB SVC150PBTW SVC150HBTW SILAVENT WINDOW/WALLFANS The SVC6 range are axial extractor fans suitable for use in domestic kitchens and light commercial environments. They may be used in other applications where a high ...

severely impair its efficiency. It is therefore, important that the fan is correctly sited using the following principles. • To ensure maximum air flow through the whole room, mount in the window, wall or ceiling furthermost from the air inlet point at high level. • Do not position a fan where temperatures are likely to exceed 50ºC (for example above a cooker hob or ...

REASSEMBLY Reassemble the fan unit in reverse order. When reassembling the fan unit it is important not to over-tighten any screw or the clamp nuts. NOTE: Liftingthetopedgeofthefrontcoverwillmakeiteasiertoremove. WARNING Positioning of th ...

(3mm) isolation provided before the room light switch and suitably fused, in accordance with IEE Regulations. Window Fans should be connected to power supply using a flexible cord with conductors of between 0.75mm2 and 1.5mm2 only. Wall and ceiling ...

mount or flush fit the SVC6 fan unit. SURFACEMOUNTING Cut a hole through wall in desired position to take the 150mm duct supplied in the fixing kit. It is important that there is at least a 5º downward slope towards the outside to allow for condensation drainage. The duct should be cut so that it is flush with both sides of the wall less 60m ...