Milwaukee 7150-21 Operator's Manual

18 ga. MARTEAU CLOUEUR CLAVADORA DE CLAVITOS, calibre 18 Cat. No. No de cat. 7150-21 OPERATOR'S MANUAL MANUEL de L'UTILISATEUR MANUAL del OPERADOR TO REDUCE THE RISK OF INJURY, USER MUST READ OPERATOR'S MANUAL. AFIN DE RÉDUIRE LES RISQUES DE BLESSURES, L’UTILISATEUR DOIT LIRE LE MANUEL DE L’OPÉRATEUR. PARA REDUCIR EL RIESGO DE ...

INSTRUCTIONS PERTAINING TO A RISK OF INJURY OR DEATH GENERAL SAFETY INSTRUCTIONS 1. To reduce the risk of injury, read all instructions before using the tool. WARNING WHEN USING TOOLS, BASIC PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING: WORK AREA 2. Keep t ...

max. 120 PSI Cat. No. 7150-21 Specifi cations Symbology Air Consumption .04 ft3/cycle at 100 psi Air Inlet 1/4 in. NPT Read the Operator's Manual Wear Eye Protection Keep hands away Fastener Length min. 0.625" max. 2.125" Collation Angle 0° Fastener Size 18 gauge Actuate To cause mo ...

8. Air inlet 9. Pusher release button 10. Pusher assembly 11. Magazine 12. Extra no-mar pad storage (on back of magazine) 13. Nameplate (on back of magazine) 14. Warning label (on back of magazi ...

1. Lay the tool on its side and point the nose of the tool away from yourself and others. 2. Press the pusher release button and gently slide back the pusher assembly. Do not allow the pusher assembly to slide back fast. 1. Lay the tool on its side and point the nose of the tool away from yourself and others. 2. Disconnect the ...

The selectable trigger can be set to either Single Sequential Actuation mode or Contact Actuation mode. 1. Push in and hold the Actuation Selector. 2. Rotate the Selector to Single Sequen- tial Actuation (T) or Contact Actuation (TTT). 3. Release the Actuation Selector. NOTE: Be sure the selector is snapped into posit ...

Drive The amount of air pressure required will depend on the size of the fastener and the workpiece material. Fig. 7 Set to middle of range 5. Begin testing the depth of drive by driv- ing a test fastener into the same type of workpiece material used for the actual job using an air pressure of 90-95 psi. 1. Lay the ...

identical replacement parts recom- mended by the manufacturer. Tool service must be performed only by qualifi ed repair personnel. Always wear safety goggles or glasses with side shields when servicing tools. Disconnect tool from air supply be- fore servicing. Cleaning Clean dust and debris from tool ven ...