Composite-ARF Extra 300SX Instructions Manual
Text of the manual
Composite-ARF Extra 300SX (2.6m span)
Instruction Manual
Composite-ARF Extra 300SX, 2.6 m
TAVS Technology
version 1.01
Instructions for Extra 300SX IMAC-Airplane
Thank you very much for purchasing our Composite-ARF Extra 300SX all composite aircraft,
made with the revolutionary Total Area Vacuum Sandwich (TAVS) technology
It is based on our extremely successful Extra 330L (2.6m), which has been in production for 5
years, and assembly is almost identical. Therefore this Instr
Supplementary Safety Notes
Pre-flight checking:
Before every session check that all the model’s working systems function correctly, and be sure
to carry out a range check.
The first time you fly any new model aircraft we strongly recommend that you enlist the help of
an experienced modeller to help you check the model and offer advice while you are flying.
Composite-ARF Extra 300SX (2.6m span)
[email protected]
4
make the 1st flight. If you feel that the range with engine running is less then with the engine off,
please contact the radio supplier and the engine manufacturer and DON’T FLY at that time.
Check for vibrations through the whole throttle range. The engine should run smoothly with no
un
Why? Because the axis of the hinge is not at the centreline
of the aileron, so it moves slightly in and out when it trav-
els, and the aileron gets a little "bigger" in surface area
when moving up, and "smaller" when moving down. This is
why you have to set the negative differential in your trans-
mitter to compensate for the size changing. 10% is a good
st
shock absorbers. This plane is not made for crashing, but
the landing gear will take some hard landings without prob-
lems. Do not change or modify it, as the results would only
be negative. We had plenty of time and experience to engi-
neer the strength needed in this area - and we did !
The motordome and firewall are a fully integral parts of the
fuselage,
Below are the things you may need to get your Composite-ARF Extra 300SX in the air. Some of
them are mandatory, some of them can be chosen by you. What we list here are highly recom-
mended parts, and have been thoroughly tested.
1.
Power servos (min. 8 required). We highly recommend JR 8411 or 8511/8611 for all con
trol surfaces. For Futaba user
This is a very quick and easy plane to build, not requiring difficult techniques or special equip-
ment, but even the building of Composite-ARF aircraft requires some suitable tools! You will
probably have all these tools in your workshop anyway, but if not, they should be available in all
good hobby shops, or hardware stores like "Home Depot" or simil
We take great care during production at the factory to ensure that all joints are properly glued,
but of course it is wise to check these yourself and re-glue any that might just have been missed.
When sanding areas on the inside of the composite sand-
wich parts to prepare the surface for gluing something onto
it, do NOT sand through the layer of lightweigh