Metra Electronics 99-5810 Installation Instructions For Part
Read Online
Read the Metra Electronics 99-5810 Installation Instructions For Part online using the built-in PDF viewer.
Key Pages of Document
99-5810 KIT FEATURES • DIN Head Unit Provision with Pocket • ISO DIN Head Unit Provision with Pocket A) Radio Housing • B) ISO Brackets • C) ISO Trim Plate KIT COMPONENTS A Small Flat Blade Screwdriver/ Panel Removal Tool • Socket Wrench Set 1-800-221-0932 © COPYRIGHT 2007 METRA ELECTRONICS CORPORATION www.metraonline.com TOOLS REQUIRED: APPLICATIONS LINCOLN Town Car 2003-2007 C B ...
Kit Assembly - DIN Head Unit Provisionwith Pocket . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - ISO DIN Head Unit Provision with Pocket . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Final Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 TABLE OF CONTENTS 99-5810 ...
LINCOLN TOWN CAR 2003-2007 1 10 0 20 30 40 50 60 70 80 90 100 100 60 20 140 180110 120 P C H R N 2 1 MPH 0.0 MILES LINCOLN Disconnect the negative battery ter- minal to prevent an accidental short circuit. 1 Remove (2) 7mm bolts facing upward above instrument cluster/gauges. (Figure A) 2 Carefully unsnap and remove dash panel surrounding radio and instru- ment cluster/gauges. (Figure B) 3 Remove (2) 7mm bolts above clock panel and ...
B A DIN HEAD UNIT PROVISION WITH POCKET Slide the DIN cage into the Radio Housing and secure by bending the metal locking tabs down. (Figure A) 1 Slide the after-market head unit into the cage and secure. (Figure B) 2 Continue to final assembly. *Note: Refer also to the instructions included with the aftermarket radio. ...
B A ISO DIN HEAD UNIT PROVISION WITH POCKET Mount the ISO Brackets to the head unit with the screws supplied with the unit. (Figure A) 1 Slide the head unit into the radio opening until the side clips engage. (Figure B) 2 Snap the Trim plate into the Radio Housing. (Figure B) 3 Continue to final assembly. *Note: Refer also to the instructions included with the aftermarket radio. ...
FINAL ASSEMBLY (A) Strip wire ends back 1/2" B) Twist ends together C) Solder D) Tape A B C D Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter and making connections as shown. (Isolate and individ- ually tape off the ends of any unused wires to prevent electrical short circuit.) Re-connect the negative battery terminal and test the unit for proper operation. Reassemble radio and dash ass ...
www.metraonline.com ...
