Wildix W-AIR Quick Start Manual

This brief guide will allow you to set up your W-AIR Network and connect your cordless phones. W-AIR SYSTEM Wildix W-AIR Base station Wildix W-AIR Repeater Wildix W-AIR cordless phone HOW TO INSTALL Requirements Configuring the W-AIR Network Detect a gateway Create a W-AIR Network LEDs of the bases Configure the cord ...

Internet quality). It combines telephony and Internet offering a great variety of new features. The architecture consists of three simple components: Wildix W-AIR Base station Wildix W-AIR Repeater Wildix W-AIR CAT-iq cordless phone Wildix W-AIR Base station It's the basic component serving to create the wire ...

Up to 3 Repeaters connected in chain Wildix W-AIR cordless phone XML phone book Synchronization of the settings with the CTIconnect (DND etc) 2'' TFT display with graphic interface 176 x 220 pixel 262K color Polyphonic ringtones Intercom/Paging Automatic SW upgrade Wideband two-way speaker phone mode Vibration Conver ...

Requirements To use W-AIR, WMS release 2.8.X or later, PoE switches and a DCHP server are required. If you are using a WMS integrated DHCP Server, go to Settings → System → DHCP Server and search for the device among the DHCP leases. Configuring the W-AIR Network Detect a gateway Go to Devices on WMS page, find t ...

Note: The device on top will be configured as Master of the network (M). The gateways will make Radio sync with each other automatically to extend the work range if possible. LEDs of the bases ● the LED blinks purple when the base is rebooting ● the LED blinks red when the base reports a configuration error ● t ...

The phones can be registered manually (e.g. if a phone belongs to another network) ● Verify that there is only one active W-AIR Network ● Press the Settings key ● Select Connectivity ● Select Deregister, enter 0000 as PIN then press Yes ● Select Register, enter 0000 as Access code then press OK ● The cord ...

Technical Notes How to check the Radio Coverage Cordless phone ● Press the Settings key ● Type *service* (*7378423*). ● Select the line Site survey mode on the administrator menu ● The phone will show up to 5 bases (RPN) and the coverage value. Note: For a good conversation and a correct handover between base ...

The following radio related issues must be considered before deploying a typical WILDIX W-AIR VoIP System. They include: ● Building Penetration: when a signal strikes on a building it is diffracted or absorbed; therefore the signal can be reduced. The amount of absorption depends on the building and its environment ...

coverage for the rooms in the inner circle on all floors (e.g. hotels). In large halls, Base stations/Repeaters should be installed vertically in the middle of the space below the drop ceiling. ● Mounting Positions: when Base stations and Repeaters are mounted vertically on a wall, the radio coverage in front of th ...