Sharp SMD2470AS Installation Manaul

Text of Sharp SMD2470AS Installation Manaul

Sharp SMD2470AS lVlicrowave Drawer : SMDZ470AS

INSTATTATIOII MANUAT INSTALLATION AND SERVICE IVTUST BE PERFORMED BY A OUALIFIED INSTALLER" IMPORTANT: SAVE IhiS INSIAIIAIION MANUAI FOR I-()CAL ELECTRICAL INSPECTOR'S USE" READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE For SAFETY C0NSIDERATI0NS do not install drawer in any combustible cabinetry, which is not in accord with the stated clearances and dimensions on page 2. See Figure 1, Remove all packing material

' Dimensions that are shown in Figure 1 must be used. Given

dimensions provide minimum clearance, Locate electrical outlet in the shaded area in the upper left_hand corner of the cutout. See Figure 5. . Contact surface must be solirJ and level, pay special attention to the floor on which the Microwave prawer will sit, T,he floor ofthe opening shouid be constructed ofplywood strong enough to support the weight ofthe oven (about 100 pounclsi. Check location

NORMAL INSTALLATION STEPS

ANTI.TIP BLOCK INSTALLATION INSTRUCTIONS To reduce the risk of tipping of the drawer, the AntitTip btock must be properly installed located 14 13lrc-inches above the florlr on which the Microwave Drawer will sit, The 6_inch Anti_Tip block must be provided by the installer. See Figures 1 and 4, f!9. a1li+in biock prevenrs serious injury that might resulr frorn spilled hot liquids, If the Micrnwave Drawer is evermoved to a different

Place the drawer adjacent to the wall or

cabinet opening. Plug the power supply cord into the electrical outlet" Carefully guide the drawer into the prepared opening, Avoid pinching the cord between the oven and the vlall. The name plate includes moclel an

Sharp Microwave Oven Owners Instructions: