Kestrel 1000 Instruction Manual

3000, 3500 & 3500NV, 3500DT NKhome.com 800.784.4221 Weather & Environmental Meters ...

Depending on your location and environment, conditions may change rapidly. Rapid temperature and humidity changes (i.e., moving your meter from indoors to outdoors) may cause inaccurate readings of temperature and humidity, as well as all readings that rely on either of these values. Before relying on Kestrel Weather & Environmental Meter re ...

Getting to Know Your Kestrel.............................................5 Getting Started......................................................................6 Setup + Options.....................................................................6 Barometric Pressure & Altitude Adjustment..................7 Measurement Notes....................................... ...

1000 2000 2500 3000 3500 3500DT Wind Speed SPd mph | kt | B | m/s | ft/min | km/h • • • • • • Temperature dEG ˚F | ˚C • • • • • Wind Chill chill ˚F | ˚C • • • • Relative Humidity % r.h. % • • • Heat Stress Index % H.I ˚F | ˚C • • Dewpoint Temp d.P. ˚F | ˚C • • • Barometric Pressure bAro inHg | hPA | mb • • • Altitude Alt m | ft • • • Wet Bulb Temp b ...

TEMPERATURE THERMISTOR (N/A on K1000) FRONT BATTERY DOOR: CR2032 COIN CELL BACK *All Kestrel Meters with temperature measurement allow you to measure air, water and snow temperature. HUMIDITY SENSOR GETTING TO KNOW YOUR KESTREL ...

• Press to turn on. • Hold for 3 seconds to turn off. The Kestrel Meter will automatically turn off if no buttons have been pressed for 45 minutes. Select Measurement Mode • Use or to access each Measurement screen • The instantaneous Measurement value will be displayed on each screen and updated once per second. Each Measurement screen will flash a brief “Hint” to clarify which Measurement is being display ...

ALTITUDE: KESTREL 2500 & KESTREL 3500 ONLY The Kestrel Meter measures “station pressure,” which changes in response to both changes in altitude and changes in atmo- sphere. Barometric pressure is a measurement of the air pressure adjusted to sea level. To obtain accurate barometric pressure and altitude readings, you must first enter EITHER your loca- tion’s current barometric pressure OR your current altit ...

or until you see “MAX” appear at bottom of screen. Press again to view average wind gust. “AVG” will appear at bottom of screen. Both Max and Average are reset each time the unit is powered down. To restart averaging, simply turn the unit off and back on again. Hold Mode Hold Mode can be useful for taking measurements when you are unable to view the display. • Hold down , then ...

When your display becomes dim or disappears, you need to change the battery. Use a US nickel or similar coin to twist open the battery compartment. Replace battery with a new, clean CR2032 coin-cell battery, with positive side (+) facing up. CR2032 batteries are available in most stores that sell batteries. When replacing the battery door, be sure to keep the black rubber o-ring seated in the groove on the case back. MAINTENANCE ...

1% after 100 hours of use at 16 MPH | 7 m/s. Drift increases with higher-speed use. For most users, the impeller will provide accurate wind speed/air flow readings for years if not physically damaged. However, if your application requires extremely high precision or if you perform frequent high- speed readings, we recommend you replace your impeller at one-year intervals. Every replacement imp ...

for a period of FIVE YEARS from the date of its first consumer purchase. NK will repair or replace any defec- tive meter or part when notified within the warranty period, and will return the meter via domestic ground shipping or NK’s choice of method of international shipping at no charge. The following are excluded from warranty coverage: damag ...

designed & manufactured in the U.S.A. NIELSEN-KELLERMAN 21 Creek Circle, Boothwyn, PA 19061 Phone: (610) 447-1555 Fax: (610) 447-1577 Web: NKhome.com Email: [email protected] Please register your Kestrel Meter at NKhome.com 319012_3_15.01.28 ...