Kobold DW 575 Operating Instructions And Useful Tips

contain important details on the use, safety and maintenance of the lighting equipment. Keep these operating instructions in a safe place and pass them on to further users if necessary. Please observe these safety instructions. Contents Page Important safety instructions 3 1. Start up 5 2. Operation of the lamp 6 3. Co ...

When using your lighting equipment, basic safety precautions should always be followed, including: 1. The fixture should only be used by qualified personnel 2. Read and understand all instructions before using 3. The equipment must not be used by children. Close supervision is necessary when any fixture is used near children. Do not leave equipment unattended. 4. The fixture and the accessories mounted onto the fixture may h ...

- For safety reasons, always disconnect the lamp base cable from the ballast unit before opening the fixture for any purpose (e.g. to replace the lamp). - To ensure maximum service life of the fixture, allow it to heat up for about 3 minutes without interruption. Always heat up with ballast dimmer set to full power. - Because the unit emits a great deal of heat, the fixture must be located at a safe distance whenever it ...

safety glass. The safety glass is integrated into the reflector or Softbox adapter and serves to protect equally against broken lamps as well as noxious UV- radiation. The fixture may therefore never be used without a reflector or Softbox adapter with an intact safety glass. A cut-off switch is provided to protect the DW 575 and DW 800. Always ...

Remote control (on): The ballast units are supplied with an active remote control mode. The function is as follows: If the operating fixture becomes switched off due to an interruption of the mains supply, it will turn on again, as soon as the mains supply begins to function. Remote control (off): If the fixture should not be switched on automatically when the current comes back, this function can be activated on the ballast uni ...

4-leaf barn door: Unlock and flip up the top barn door claw (17) by pushing in the marked direction. The 4-leaf barn door for the PAR reflector can now be inserted from above in the outer fixed groove of the three lower barn door claws. Lower the top barn door claw until it engages and locks. To ensure that the barn door is securely fitted, rotate the barn door. PAR lens, Fresnel lens: Un ...

the lamp while inserting it, and handle the lamp only by the base in order to keep the quartz glass free of fingerprints. Any fingerprints or other marks on the quartz glass must be immediately removed with a clean cloth moistened with solvent or alcohol. No warranty or replacement obligation applies to lamps that have been damaged by improper insertion. - Before mounting ...

13200 / 870 Lux 20200 / 1430 Lux Photometric in 5 m with PAR reflector (without PAR lens) 100000 Lux 115000 Lux Focus range with Open Face reflector 12° - 70° Dimming range (with electronic ballast unit) 100% - 60% Colour temperature depending on the used lamp ~ 5900 K Lamp ...

parts Open Face reflector for DW 575/DW 800 Article no. 741-0577 PAR reflector 575/DW 800 Article no. 741-0576 4-leaf barn door, rotatable with filter insertion for Open Face reflector Article no. 741-0730 4-leaf barn door, rotatable, for PAR reflector Article no. 741-0731 Diffusion filter, with frame for Open Face reflector Article no. 713-0513 Conversion filter, 3200K, for Open Face reflector Article no. ...