Pertech 5300 Manuals

Pertech 5300 Setup manual (9 pages)

• Identifier: id-983144
• Brand: Pertech
• Device: Pertech 5300 Printer
• Type: Setup manual, PDF
• Key Aspects: Troubleshooting Information, Technical Drawings and Schematics
• UPD Date: 02.06.2026
• Source File: 1175356.pdf
• Pages: 9
• Description: Operating and setup manual for the Pertech 5300. This documentation highlights features and system setup, device safety checks, operating instructions.

Key Pages and Contents:

• 6 Loading Paper

  53X1 Printer Roll paper must be 3 inches wide with a maximum diameter of 3.5 inches. Ink Jet printers can accommodate 1 paper ply. Impact printers can accommodate 1 or two paper plys. Paper and other printer consumables may be purchased from Pertech by calling 1-800-800-661

• Unpacking the Printer

  Save all packing materials in case you need to repack the printer. To report a printer that was damaged during shipping, see “Contact Information” on the last page of this Guide. To repack the printer, consult the above illustration and use the origi- nal packin

• Federal Communications Commission (FCC) Radio

  Frequency Interference Statement Warning Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Note This equipment has been tested and found to co

• 1. Press the Power Switch to turn on the printer.

  2. Open the top cover. The cradle moves to an accessible position. 3. Lift the print cartridge out and discard if replacing print cartridge. Skip this step if no print cartridge is installed. Note: Replacement ink jet pri

Pertech 5300 Operation & user’s manual (3 pages)

• Identifier: id-876669
• Brand: Pertech
• Device: Pertech 5300 Printer
• Type: Operation & user’s manual, PDF
• Key Aspects: Comparative Analysis of Various Features, Health and Safety Information, Updates on New Features
• UPD Date: 09.06.2026
• Source File: 867892.pdf
• Pages: 3
• Description: Complete technical documentation for the Pertech 5300. It provides information on safety and power management, safety, component overview, software configuration.

Key Pages and Contents:

• Pertech Industries Virtual COM User’s Guide Rev 02

  1. Introduction 2. What’s Required?    3. Installing the Driver 4. Assign the COM Port Number  5. Test the Application 

• Pertech Industries Virtual COM User’s Guide Rev 02

  VIRTUAL COM USERS GUIDE

• Pertech Industries Virtual COM User’s Guide Rev 02

  Trouble Shooting  o o o o o Figure 1 Figure 2 Verify the printer's USB configuration "Driver Class" configured to "Virtual COM". o

Pertech 5300 Operation & user’s manual (40 pages)

• Identifier: id-66274
• Brand: Pertech
• Device: Pertech 5300 Printer
• Type: Operation & user’s manual, PDF
• Key Aspects: Usage Recommendations Under Different Conditions, Common Use Cases Explained, User Group Forum Links
• UPD Date: 06.06.2026
• Source File: 396223.pdf
• Pages: 40
• Description: Practical user guide for the Pertech 5300. The guide describes usage and system setup, network setup, safety guidelines.

Key Pages and Contents:

• Pertech Resources Inc.

  November 2005 220321A 31

• Pertech Resources Inc.

  November 2005 220321A 27 Trouble Shooting Printer Problems The printer will enter a Fault Mode and will not operate when certain failure conditions are encountered. Confirmation of this condition can be accomplished by the host on the DTR (pin 8) or status with an RS-232 int

• Pertech Resources Inc.

  November 2005 220321A 1 About The Printer Unpacking the Printer Save all packing materials in case you need to repack the printer. To report a printer that was damaged during shipping, see “Contact Information” on the last page of this Guide. To repack the printer, consul

• Pertech Resources Inc.

  November 2005 220321A 7 Cables and Connections RS232 Serial Interface The 5300 comes with two communication interfaces, RS-232 Serial and USB. Additionally, the printer has a cash drawer port and a three pin mini din power coupling. The RS-232 interface connector is a DB9M