Pertech 5300 Operation & User’s Manual

Pertech 5300 November 2005 220321A 18 The user can choose to Lock Settings if desired. This prevents accidental changes from occurring in both the host communication settings and configuration items. When exiting the utility via the “Exit” button, there is a prompt to save the current settings to disk. If the user clicks “Yes”, then ther ...

Pertech 5300 November 2005 220321A 2 Ordering Paper and Supplies The following section lists the paper and supplies available for order. In addition to paper and ribbons, parts, service and repair may be obtained by calling 1-800-800-6614. Paper: Call: 1-800-800-6614 Paper Part Number Ink Jet 5351 One Ply............................. ...

Pertech 5300 November 2005 220321A III Important Information to the User In order to ensure compliance with the Product Safety, FCC and CE marking requirements. you must use the power supply, power cord, and interface cable which were shipped with this product or which meet the following parameters: Power Supply Input power to this product must b ...

Pertech 5300 November 2005 220321A 30 Specifications Dimensions Height 5.38” / (136.65 mm) Width 6.92” / (175.77 mm) Length 8.9” / (226.06 mm) Weight R/V Models 5.75 Lbs. / (2.61 kg) Ext. Power Supply 1.12 Lbs. Max. / (.051 kg) Power Supply Impact: 60 Watt 24V Brick or Inkjet:15 Watt 24V Wall Mount Roll Paper Wi ...

Pertech 5300 November 2005 220321A 32 Index A A470 Compatibility Mode .................. 24, V Additional information............................. VI Agency Listings ......................................30 ASCII 8, .................................................15 Available Models: ................................... VI B Baud ................. ...

Pertech 5300 November 2005 220321A V Configuration & Diagnostic Print Tests ..........................................................17 Configuration Utility Program....................................................................17 Printer Control Language...............................................................18 Font ................. ...

November 2005 220321A 21 After the printer is set up, you can run two print diagnostic reports / tests and enter the configuration menu. Below is an example of the configuration report. 1 Press and hold the Paper Feed Button and then press the Power Switch to turn the printer on and start the first test. Validation printers will ...

November 2005 220321A 5 2.75 Inches 1.75 Document Stop Right Edge of Form Aligned with Right Edge of Receipt Retail Endorsement. To center justify check in print zone, docu- ment guide is 2.625” from dot column #1 1 Inch Print field is 2.5” Wide Right Justify Validation Print Fields The 5300 series printer has 2.5 inch wide printf ...

Pertech 5300 November 2005 220321A 23 Serial Number: ******** Main Firmware Revision: * ** *** CRC: **** Boot Firmware Revision: * ** *** CRC: **** Printer Control Language PCL: ACL Language Diag Mode: Standard Print Auto LF: CR = CR Soft Fault Recover: Automatic Font: Font: Standard Font Quality: Draft Intl Char set: USA Code Page: 437 USA Receip ...

Pertech 5300 November 2005 220321A 22 ================================= Press paper feed to change configuration SET-UP INSTRUCTIONS PRESSING THE PAPER FEED BUTTON WHILE THE GREEN LIGHT IS FLASHING WILL REJECT THE LAST PRINTED PARAMETER. IF THE BUTTON IS NOT PRESSED WITHIN 5 SECONDS. THE PARAM- ETER WILL BE ACCEPTED AND THE NEXT ...